Mazda CX-5 Service & Repair Manual: Radiator
Purpose, Function
-
The radiator disperses the engine coolant heat flowing internally by receiving against the vehicle while it is driven or air flow produced by the cooling fan.
Construction
-
The radiator is installed to the front of the engine compartment.
-
Four mounting rubbers are utilized to decrease vibration.
-
A down-flow radiator with corrugated fins has been adopted.
-
The radiator tanks are made of plastic and the core is made of aluminum for weight reduction.
Radiator Removal/Installation
WARNING:
Never remove the cooling system cap or loosen the radiator drain plug while
the engine is running, or when the engine and radiator are hot. Scalding engine
coolant and steam may ...
Shroud Panel Removal/Installation
CAUTION:
Since the servicing is performed with the hood open, secure the hood using
a piece of wood to prevent it from falling.
1. Disconnect the negative battery cable..
2. Remove ...
Other materials:
Front Console Box Removal/Installation
NOTE:
Affix protective tape to the position shown in the figure.
1. Insert a tape-wrapped flathead screwdriver in the position indicated by the
arrow in the figure and detach clips A.
2. Pull the front console box in the direction of the arrow (2) and remove it
while d ...
Ventilator Grille Removal/Installation
Side Ventilator Grille
Driver-side
1. Disconnect the negative battery cable..
2. Remove the switch panel..
3. Insert your hand from the area where the switch panel was installed, remove
the side ventilator grille in the direction of the arrow shown in the figure while
detaching hooks A.
...
Rear Pillar (Outer) Installation [Panel Replacement]
Symbol Mark
Installation Procedure
1. When installing new parts, measure and adjust the body as necessary to conform
with standard dimensions.
2. Drill holes for the plug welding before installing the new parts.
3. After temporarily installing new parts, make sure the related parts fit p ...
