Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Quick Release Connector Removal/Installation

Mazda CX-5 Service & Repair Manual / Engine / Fuel / Quick Release Connector Removal/Installation

WARNING:

CAUTION:

Quick Release Connector Type

CAUTION:

U.S.A. and CANADA


Except U.S.A. and CANADA


Type A Removal

1. Complete the “BEFORE SERVICE PRECAUTION”..

2. Move the retainer upward using a small flathead screwdriver or a similar tool.


3. Pull out the fuel hose straight from the fuel pipe and disconnect it.

4. Cover the disconnected quick release connector and fuel pipe with vinyl sheeting or a similar material to prevent it from getting scratched or dirty.

Type B Removal

CAUTION:

1. Complete the “BEFORE SERVICE PRECAUTION”..

2. Insert the SST into the quick release connector.


3. Pull the fuel hose straight out from the fuel pipe and disconnect it.

4. Cover the disconnected quick release connector and fuel pipe with vinyl sheeting or a similar material to prevent it from getting scratched or dirty.

Type A Installation

NOTE:

1. Inspect the fuel hose and fuel pipe sealing surface for damage and deformation.

2. Apply a small amount of clean engine oil to the sealing surface of the fuel pipe.

3. Install the quick release connector.


4. Lightly pull and push the quick release connector a few times by hand, and then verify that it is connected securely.

5. Complete the “AFTER SERVICE PRECAUTION”..

Type B Installation

NOTE:

1. Inspect the fuel hose and fuel pipe sealing surface for damage and deformation.

2. Apply a small amount of clean engine oil to the sealing surface of the fuel pipe.

3. Install a new retainer to the quick release connector.

4. Reconnect the fuel hose straight to the fuel pipe until a click is heard.

5. Lightly pull and push the quick release connector a few times by hand, and then verify that it is connected securely.

6. Complete the “AFTER SERVICE PRECAUTION”..

Quick Release (Fuel System) Connector
Purpose, Function Serviceability has been improved by the easy disconnection/connection. Construction The following types of the quick release connectors are used. U.S.A. and CAN ...

Returnless Fuel System
Purpose, Outline Fuel evaporation in the fuel tank is reduced by adjusting the fuel amount (fuel pressure) ejected from the fuel pump and preventing fuel warmed in the engine compartment ...

Other materials:

Sail Garnish Removal/Installation
1. Open the front door. 2. Affix protective tape to the position shown in the figure. 3. Insert a tape-wrapped flathead screwdriver into the shown in the figure and remove the clip A in the direction of arrow (1). 4. Pull the sail garnish in the direction of the arrow (2) and remove it w ...

D Pillar Speaker Inspection
D-pillar speaker 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk board. b. Trunk end trim. c. Rear scuff plate. d. Trunk side trim. e. D-pillar trim. 3. Disconnect the D-pillar speaker connector.. 4. Verify that the resistance between the D-pillar ...

Blind Spot Monitoring (BSM) System
Blind Spot Monitoring (BSM) System The Blind Spot Monitoring (BSM) system is designed to assist the driver by monitoring blind spots on both sides of the vehicle to the rear in certain situations such as when changing lanes on roads and freeways. The BSM system monitors the detection areas on ...

© 2016-2022 Copyright www.mcx5.org