Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Purge Solenoid Valve Removal/Installation

Mazda CX-5 Service & Repair Manual / Engine / Emissions / Purge Solenoid Valve Removal/Installation

1. Disconnect the negative battery cable..

2. Remove the plug hole plate..

3. Remove the air cleaner and air hose as a single unit..

4. Disconnect the high pressure fuel pump connector.

5. Disconnect the harness clip as shown in the figure.


6. Remove in the order indicated in the table.



1

Evaporative hose No.1

(See Evaporative Hose No.1 Installation Note.)

2

Catch tank

3

Evaporative hose No.2

4

Purge solenoid valve connector

5

Evaporative hose No.3

(See Evaporative Hose No.3 Installation Note.)

6

Purge solenoid valve bracket installation bolt

7

Purge solenoid valve

(See Purge Solenoid Valve Installation Note.)


7. Install in the reverse order of removal.

Purge Solenoid Valve Installation Note

1. Temporarily install the purge solenoid valve to the bracket.

2. Lift up and tighten the purge solenoid valve as shown in the figure.


Evaporative Hose No.3 Installation Note

1. Install the evaporative hose No.3 as shown in the figure.


Evaporative Hose No.1 Installation Note

1. Install the evaporative hose No.1 as shown in the figure.


Purge Solenoid Valve Inspection
Airflow Inspection 1. Disconnect the negative battery cable.. 2. Remove the purge solenoid valve.. 3. Inspect airflow between the ports under the following conditions. ...

Purge Solenoid Valve
Purpose, Function Introduces evaporative gas absorbed by the charcoal canister to the intake manifold. The purge solenoid valve opens according to the control signal from the PCM. ...

Other materials:

Cargo Compartment Light Removal/Installation
1. Disconnect the negative battery cable.. 2. To prevent scratches or damage, affix protective tape to the position shown in the figure. CAUTION: If a flathead screwdriver is inserted into the gap between the cargo compartment light and trunk side trim, the trunk side trim could int ...

Brake Fluid Pressure Sensor Inspection
1. Switch the ignition to off. 2. Remove the clips. 3. Set the splash shield out of the way. 4. Disconnect the brake pipe from the LF brake hose. 5. Remove the clip. 6. Remove the LF brake hose from the bracket. 7. Detach the brake pipe from the pipe holder. 8. Install the SST ...

Battery
WARNING Wash hands after handling the battery and related accessories: Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Read the following precautions carefully before using the ...

© 2016-2022 Copyright www.mcx5.org