Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Propeller Shaft Removal/Installation

Mazda CX-5 Service & Repair Manual / Drivetrain / Driveline / Driveshafts / Propeller Shaft Removal/Installation

CAUTION:

1. Remove the floor under cover..

2. Remove the center under cover..

3. Remove the insulator (exhaust system)..

4. Remove the tunnel member..

5. Remove the brace bar..

6. Remove in the order indicated in the figure.

7. Install in the reverse order of removal.



1

Nut (rear)

2

Nut (front)

3

Nut (center bearing support)

4

Bush, spacer

5

Propeller shaft

(SeePropeller Shaft Installation Note.)


Propeller Shaft Removal Note

CAUTION:

1. Before removing the nut, place alignment marks on the companion flange (front) and constant velocity joint, and on the coupling component (rear) and yoke.


2. Loosen the nuts (front, rear, center bearing support).

3. Remove the front and rear nuts.

CAUTION:

4. Press the propeller shaft and remove it from the rear side.

CAUTION:

5. Remove the center bearing support nut, then remove the propeller shaft

Propeller Shaft Installation Note

CAUTION:

NOTE:

1. Degrease the tightening area.

2. Align the alignment marks, and temporarily install the nuts (front, rear, center bearing support).


CAUTION:

3. Tighten the nut (front) with specified torque first, and then install the other nuts.

4. Perform a road test and verify that there is no abnormal vibration or noise.

Propeller Shaft On Vehicle Inspection
Joint Area Excessive Play Inspection 1. Shake the universal joint by hand and verify that there is no excessive play. 2. If there is any excessive play, replace the propeller shaft.. Propell ...

Rear Drive Shaft
Purpose, Function Engine noise and vibration have been reduced due to adoption of a bell joint on the wheel side of the constant velocity joint. A low noise and vibration double offs ...

Other materials:

Outer Mirror Glass Inspection
Heated Outer Mirror 1. Disconnect the negative battery cable.. 2. Remove the outer mirror glass.. 3. Verify that the resistance and continuity between the heated outer mirror terminals is as indicated in the table. If not as indicated in the table, or if the resistance is not with ...

Manual Transaxle Shift Mechanism Removal/Installation [C66 M R]
1. Disconnect the negative battery cable.. 2. Remove the shift lever using the following procedure: a. Remove the upper panel.. b. Remove the shift lever knob. c. Remove the shift panel.. d. Remove the side wall.. e. Remove the rear console.. f. Press the tabs on the control cable ...

On Board Diagnostic System Simulation Inspection [Fw6 A EL, Fw6 Ax EL]
1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “TCM”. 3. Select the simulation items from the PID table. 4. Perform the act ...

© 2016-2022 Copyright www.mcx5.org