Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Pressure Sensor [Two Step Deployment Control System]

Mazda CX-5 Service & Repair Manual / Engine / Emissions / Pressure Sensor [Two Step Deployment Control System]

Purpose

Function

Construction


Operation

1. If the vehicle is involved in a side-impact collision, air pressure is generated in the sealed front door and applied to the pressure sensor.


2. The pressure detection sensor built into the pressure sensor detects the pressure and converts the pressure into an electrical signal at the signal processing circuit.

3. The pressure signal, which is converted to an electrical signal, is sent to the SAS control module.


Fail-safe

Pressure Sensor Removal/Installation [Two Step Deployment Control System]
WARNING: Handling the pressure sensor improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the air bag system service warnings and cautio ...

Refrigerant Pressure Sensor Inspection [Full Auto Air Conditioner]
1. Install the manifold gauge. 2. Verify the high-pressure side reading of the manifold gauge. 3. Measure the terminal voltage at PCM terminal 2BB, 2AX and 2AJ 4. Using the graph below, measure ...

Other materials:

Rear Shock Absorber Removal/Installation
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 1 Rear shock absorber upper nut (See Rear Shock Absorber Upper nut Installation Note.) 2 Rear shock absorber lower bolt 3 ...

Interior Lighting System
Outline A room light control system has been adopted in which illumination time and illumination level of the interior lights change. The rear body control module (RBCM) performs room light control system fail-safe.. Structural View System Wiring Diagram ...

Procedure [Plastic Body Parts]
Repair of polypropylene bumpers having damage that has reached the surface of the polypropylene and are too serious to be restored by painting only. 1. Cut the rough edges around the damage with a knife to make it smooth. Sand the area with a sander to make an angle of about 45°. 2. ...

© 2016-2022 Copyright www.mcx5.org