Mazda CX-5 Service & Repair Manual: Pressure Control Valve [Skyactiv G 2.0]
U.S.A. And CANADA
Purpose, function
-
Prevents fuel tank damage by suppressing the vacuum applied to the fuel tank while the purge solenoid valve is open.
-
Suppresses the vacuum applied from the charcoal canister side to the fuel tank.
Construction
-
Integrated with the evaporative hose and installed to the side of the fuel tank.
-
There is an orifice inside the pressure control valve.
Operation
-
When the purge solenoid valve is open, the intake manifold vacuum is applied between the purge solenoid valve and the fuel tank. The pressure control valve suppresses the intake manifold vacuum applied to the fuel tank. In addition, to lead the evaporative gas generated inside the fuel tank to the charcoal canister, it does not suppress the evaporative gas flow (positive pressure) from the fuel tank side.
Pressure Control Valve Inspection [Skyactiv G 2.0]
1. Remove the pressure control valve assembly..
CAUTION:
Do not apply a pressure 36 kPa {0.37 kgf/cm2, 5.2 psi} or more. Doing so
will damage the pressure control valve and evaporative ho ...
Steering Shaft Inspection
1. Inspect the steering column for excessive play and damage.
2. Verify that the clearance between the projection on the steering column shown
in the figure and the bracket is less than 2.0 mm {0. ...
Other materials:
Hood Latch Switch
Purpose
Detects the open/closed condition of the hood.
Function
The hood latch switch is utilized in the theft-deterrent system control.
For the theft-deterrent system, refer to (see THEFT-DETERRENT SYSTEM.).
Construction
Built into the hood latch ...
Front Door Key Cylinder Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the service hole cover.
3. Detach the screw from the front door key cylinder.
NOTE:
The screw cannot be removed because the front outer handle bracket has a
stopper which prevents the screw from falling.
4. While pre ...
Light Bulbs
WARNING
Do not replace the xenon fusion bulbs yourself:
Replacing the xenon fusion bulbs yourself is dangerous. Because the xenon fusion
bulbs require high voltage, you could receive an electric shock if the bulbs are
handled incorrectly. Consult an Authorized Mazda Dealer when the replaceme ...
