Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Pre Tensioner Seat Belt [Two Step Deployment Control System]

Mazda CX-5 Service & Repair Manual / Restraints / Pre Tensioner Seat Belt [Two Step Deployment Control System]

Purpose

Function


Construction


Operation

Normal operation (pre-tensioner non-operation)


Pre-tensioner activation

1. The gas generator produces gas when it receives an operation signal from the SAS control module.

2. The ball in the cylinder is pressed by the gas pressure and the ring gear is removed from its securement.

3. The ring gear is engaged with the locking base and the force of the ball being pressed out is transmitted to the retraction shaft.

4. The front seat belt is retracted in conjunction with the rotation of the retraction shaft.


Fail-safe

Pre Tensioner Seat Belt [Standard Deployment Control System]
Purpose The pre-tensioner seat belt retracts and tightens the seat belt webbing to protect the front passengers during a collision. Function The pre-tensioner seat belts operate ...

Rear Buckle Removal/Installation
1. Switch the ignition to off. 2. Disconnect the negative battery cable and wait for 1 min or more.. 3. Press the release switch, then disconnect the rear center seat belt and rear buckle. ...

Other materials:

Intake Manifold Vacuum Inspection
1. Disconnect the evaporative hose No.3 (purge solenoid valve side) and install the vacuum gauge.. 2. Verify that the intake air hoses are installed securely. 3. Warm up the engine. 4. Measure the intake manifold vacuum while idling (no load) using the vacuum gauge. If not within t ...

Fuel Gauge Sender Unit Removal/Installation [2 Wd]
WARNING: Always keep sparks and flames away from fuel when servicing the fuel system. Fuel can be easily ignited which could cause serious injury or death, and damage to equipment. Fuel line spills and leakage from the pressurized fuel system are dangerous. Fuel can ignite a ...

ABS Wheel Speed Sensor And ABS Sensor Rotor
Purpose/Function The ABS wheel-speed sensor and ABS sensor rotor detect the rotation condition of each wheel and transmit this information to the DSC HU/CM. The signal from the ABS wheel-speed sensor is the primary signal that the DSC HU/CM uses when carrying out control. ...

© 2016-2022 Copyright www.mcx5.org