Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Power Window Subswitch Removal/Installation

Mazda CX-5 Service & Repair Manual / Body / Glass & Windows / Power Window Subswitch Removal/Installation

1. Disconnect the negative battery cable..

2. Remove the cover A.


3. Insert a tape-wrapped fastener remover shown in the figure and remove the tab B in the direction of arrow (1).


4. Slide the power window subswitch cover in the direction of the arrow (2) shown in the figure and remove the tab C.

5. Disconnect the power window subswitch connector.

6. Pull the edge of power window subswitch cover in the direction of arrow (3) and detach the tab D.


7. Remove the power window subswitch in the direction of arrow (4) shown in the figure.

8. Install in the reverse order of removal.

Power Window Subswitch Inspection
1. Disconnect the negative battery cable.. 2. Remove the power window subswitch.. 3. Verify that the continuity between the power window subswitch terminals is as indicated in the table. ...

Power Window System
Outline A power window system that enables automatic opening/closing of the door glass has been adopted. The driver's side door glass can be opened/closed automatically or manual ...

Other materials:

Front Center Speaker Inspection
1. Disconnect the negative battery cable.. 2. Remove the center speaker grille.. 3. Remove the front center speaker.. 4. Verify that the resistance between the front center speaker terminals is as indicated in the table. If not as indicated in the table, replace the front center ...

Air Fuel Ratio (A/F) Sensor Heater Control [Skyactiv G 2.0]
Outline Based on the control of the A/F sensor heater, a stabilized oxygen concentration is detected even at low exhaust temperatures, and feedback control of fuel injection even at cold engine start is made possible for improved cold temperature exhaust emission performance. ...

Vacuum Pump Removal/Installation
1. Remove the plug hole plate.. 2. Remove the battery.. 3. Set the PCM wiring harness out of the way. 4. Disconnect the vacuum hose from the vacuum pump.. 5. Remove in the order shown in the table. 6. Install in the reverse order of removal. 1 Vacuum hose ...

© 2016-2024 Copyright www.mcx5.org