Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Power Window Motor Inspection

Mazda CX-5 Service & Repair Manual / Body / Glass & Windows / Power Window Motor Inspection

Front driver side

1. Disconnect the negative battery cable..

2. Remove the inner garnish..

3. Remove the front door trim..

4. Disconnect the power window motor connector.

5. Apply battery positive voltage and connect the ground to power window motor terminals E and F, and then inspect the power window motor operation.



Operation

Terminal

E

F

Open

B+

Ground

Close

Ground

B+


6. Connect the battery positive voltage to power window motor terminal D and connect terminal C to ground.

7. Operate the power window motor and verify the wave patterns for terminals A and B.


Front passenger side

1. Disconnect the negative battery cable..

2. Remove the inner garnish..

3. Remove the front door trim..

4. Disconnect the power window motor connector.

5. Apply battery positive voltage and connect the ground to power window motor terminals E and F, and then inspect the power window motor operation.



Operation

Terminal

E

F

Close

B+

Ground

Open

Ground

B+


Rear

1. Disconnect the negative battery cable..

2. Remove the rear door trim.

3. Disconnect the power window motor connector.

4. Apply battery positive voltage and connect the ground to power window motor terminals E and F, and then inspect the power window motor operation.



Operation

Terminal

E

F

Close

B+

Ground

Open

Ground

B+


Power Window Motor
Purpose The power window motor transmits rotation force to the power window regulator to open/close the door glass. Function The power window motor rotates clockwise/counterclockwise when it rece ...

Power Window Motor Removal/Installation
Front Power Window Motor 1. Fully lower the front door glass. 2. Disconnect the negative battery cable.. 3. Remove the inner garnish.. 4. Remove the front door trim.. 5. Disconnect the front ...

Other materials:

Clutch Pedal Position (CPP) Switch [Skyactiv G 2.0]
Purpose/Function Detects the connection status of the clutch. Construction Installed on the clutch pedal. An ON/OFF type switch has been adopted. Operation Inputs the CPP switch on/off signal to the PCM. The contact point is on and voltage ...

Clock Spring Inspection [Standard Deployment Control System]
1. Disconnect the negative battery cable and wait for 1 min or more.. 2. Remove the driver?side air bag module.. 3. Remove the steering wheel.. 4. Remove the column cover.. 5. Remove the clock spring.. 6. Verify that the continuity is as indicated in the table. If not as indicated ...

Refrigerant Pressure Sensor [Manual Air Conditioner]
Purpose The refrigerant pressure sensor detects the refrigerant pressure in the refrigerant cycle. Function The refrigerant pressure sensor converts the detected refrigerant pressure to an electric signal and sends it to the PCM. Construction The refriger ...

© 2016-2024 Copyright www.mcx5.org