1. Disconnect the negative battery cable..
2. Remove the cover A.
3. Insert a tape-wrapped fastener remover shown in the figure and remove the tab B in the direction of arrow (1).
4. Slide the power window main switch cover in the direction of the arrow (2) shown in the figure and remove the tab C.
5. Disconnect the power window main switch connector.
6. Pull the edge of power window main switch cover in the direction of arrow (3) and detach tabs D.
7. Remove the power window main switch in the direction of arrow (4) shown in the figure.
8. Install in the reverse order of removal.
Antenna Feeder No.3 Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. B-pillar lower trim.
b. Front seat belt adjusting cover.
c. Front seat belt upper anchor installation bolt.
d. B-pillar upper trim.
e. Trunk board.
f. Trunk end trim.
g. Trunk side trim.
h. D-pillar trim. ...
Engine Control System
Outline
L-jetronic*1 and D-jetronic*2 type detectors have been combined for intake
air amount detection, improving the accuracy of the intake air amount measurement.
MAF sensor adopted
MAP sensor adopted
IAT sensor No.1 and No.2 adopted
...
Cowl Grille Removal/Installation
1. Remove the windshield wiper arm and blade..
2. Pull the front fender molding in the direction of the arrow (1) while detaching
hook A.
3. Pull the front fender molding in the direction of the arrow (2) while detaching
hook B.
4. Pull the front fender molding in the direction of ...