Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Power Outer Mirror System

Mazda CX-5 Service & Repair Manual / Body / Mirrors / Power Outer Mirror System

Outline

Structural view


System wiring diagram


Function

Mirror glass adjustment function

Operation

Mirror glass adjustment (Example: Left outer mirror is adjusted upward)

1. When the upward switch is turned on (1), the up/down adjustment motor operates upward.(2)


Fail-safe

Power Outer Mirror Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the inner garnish.. 3. Remove the front door trim.. 4. Insert a tape-wrapped flathead screwdriver into the service hole and remove hooks A ...

Rear Window Defroster/Outer Mirror Heater
Outline Fogging is cleared from the rear window and outer mirror glass by heating of the filament. Structural view System wiring diagram Vehicles with full-auto air conditioner s ...

Other materials:

Pressure Control Valve Inspection [Skyactiv G 2.0]
1. Remove the pressure control valve assembly.. CAUTION: Do not apply a pressure 36 kPa {0.37 kgf/cm2, 5.2 psi} or more. Doing so will damage the pressure control valve and evaporative hose. 2. Apply a pressure of 36 kPa {0.37 kgf/cm2, 5.2 psi} to port A. 3. Verify that ther ...

Tie Rod End Inspection
1. Inspect the tie-rod end for damage and the boot for cracks. If there is any malfunction, replace the tie-rod end. 2. Inspect for excessive play. If there is any malfunction, replace the tie-rod end. 3. Rotate the tie-rod end five times. 4. Install two nuts to the ba ...

Wheel Alignment Pre Inspection
1. Park the vehicle on level ground, in an unloaded condition*, with the wheels straight forward. *: Unloaded condition.....Fuel tank is full. Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position. 2. Inspect the tire pressure. ...

© 2016-2026 Copyright www.mcx5.org