1. Disconnect the negative battery cable..
2. Remove the power outer mirror switch..
3. Verify that the continuity between the power outer mirror switch terminals is as indicated in the table.
If not as indicated in the table, replace the power outer mirror switch..
Rear Wiper Motor Inspection
1. Disconnect the negative battery cable..
2. Open the liftgate.
3. Remove the following parts:
a. Rear wiper arm and blade.
b. Liftgate upper trim.
c. Liftgate side trim.
d. Liftgate recess.
e. Liftgate lower trim.
4. Remove the rear wiper motor connector.
Rear Wiper Motor Ope ...
Seat Weight Sensor Calibration [Two Step Deployment Control System]
CAUTION:
If any of the following work is performed, perform the seat weight sensor
calibration using the M-MDS.
Replacement with a new seat weight sensor
Replacement with a new seat weight sensor control module
Replacement with new passenger-side seat pa ...
2 6 Brake [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The 2-6 brake locks the rear internal gear and reduction planetary carrier
while in 2GR and 6GR.
Construction
The 2-6 brake consists of the following parts shown in the figure.
The driven plate of the 2-6 brake does not rotate because it is c ...