Mazda CX-5 Service & Repair Manual: Power Outer Mirror Inspection
Mirror Glass Adjustment
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Power outer mirror.
3. Apply battery positive voltage and connect the ground to the power outer mirror terminals and inspect the power outer mirror operation.
-
If the power outer mirror does not operate as indicated in the table, replace the power outer mirror.
|
Mirror operation direction |
Battery positive voltage connect terminal |
Ground connect terminal |
|
Up |
C |
F |
|
Down |
F |
C |
|
Left |
I |
F |
|
Right |
F |
I |
Heated Outer Mirror Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Power outer mirror.
d. Outer mirror glass.
3. Verify that the continuity between heated outer mirror connector terminals is as indicated in the table.
-
If not as indicated in the table, replace the power outer mirror..
Blind Spot Monitoring (BSM) Warning Indicator Light Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Power outer mirror.
d. Outer mirror glass.
3. Verify that the continuity between blind spot monitoring (BSM) warning indicator light connector terminals is as indicated in the table.
-
If not as indicated in the table, replace the power outer mirror..
Power Outer Mirror
Outline
The power outer mirror adjusts the outer mirror glass position up/down and
left/right using the up/down adjustment motor and, left/right adjustment motor.
The up/down adjustm ...
Power Outer Mirror Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the inner garnish..
3. Remove the front door trim..
4. Insert a tape-wrapped flathead screwdriver into the service hole and remove
hooks A ...
Other materials:
Transaxle Range Sensor [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The transaxle range sensor detects the position of the manual valve and selector
lever.
The transaxle range sensor signal is used for automatic shift control, manual
shift control, TCC control, line pressure control, direct electric shift control,
learning co ...
Automatic Transaxle Outline [Fw6 A EL, Fw6 Ax EL]
Outline
Contribution to low fuel economy
Wide TCC range
Clutch/brake resistance reduction
Realized direct feel and quick shifting
Oil passage resistance reduction and improved clutch/brake response
b ...
Windshield Wiper And Washer Switch Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Column cover.
b. Wiper and washer switch.
3. Use a tester to measure and verify that the continuity between the windshield
wiper and washer switch terminals is as indicated in the table.
If the continu ...
