Purpose
The power MOS FET controls the blower motor rotation speed.
Function
The power MOS FET controls the supply voltage to the blower motor based on the gate voltage sent from the climate control unit, and adjusts the fan rotation speed (airflow volume).
Construction
The power MOS FET is installed to the A/C unit.
A transistor-type power MOS FET has been adopted and it is equipped with three electrodes, a source, a gate, and a drain.
Operation
The resistance between terminals B and A (between drain and source) changes according to the voltage (gate voltage) applied to terminal E (gate).
When the gate voltage increases, the resistance between terminals B and A decreases, allowing the current to flow easily. Therefore, the blower motor rotation speed increases.
When the gate voltage decreases, the resistance between terminals B and A increases, making current flow difficult. Therefore, the blower motor rotation speed decreases.
Fail-safe
Function not equipped.
Start Stop Unit Configuration (Using Read/Write Function)
NOTE:
When performing configuration, it is necessary to read the vehicle specification
information from the start stop unit before replacing it. Connect the M-MDS
to the vehicle and perform vehicle identification before removing the start
stop unit. The vehicle specification informa ...
High Pressure Fuel Pump Inspection
NOTE:
The following vacuum values are indicated by relative pressure from the fuel
pressure sensor.
1. Verify that the fuel pressure sensor is normal..
2. Connect the M-MDS to the DLC-2.
3. Switch the ignition ON (engine off).
4. Select the “FUEL_PRES”, “LOAD” and “R ...
Engine Oil Replacement
WARNING:
Hot engines and engine oil can cause severe burns. Turn off the engine and
wait until it and the engine oil have cooled.
A vehicle that is lifted but not securely supported on safety stands is dangerous.
It can slip or fall, causing death or serious injury. Never work ...