Mazda CX-5 Service & Repair Manual: Polypropylene Bumper Repair [Plastic Body Parts]

Mudguard Removal/Installation

1. Remove the front over fender.. 2. Remove screws A. 3. Remove fasteners B. 4. Pull the mudguard in the direction of the arrow shown in the figure. 5. Install in the reverse order of ...

Rear Beltline Molding Removal/Installation

CAUTION: Affix protective tape to the position shown in the figure. 1. Fully open the rear door glass. 2. Insert a tape-wrapped flathead screwdriver and then detach the clip A in ...

Other materials:

When Liftgate Cannot be Opened
When Liftgate Cannot be Opened If the vehicle battery is dead or there is a malfunction in the electrical system and the liftgate can not be opened, perform the following procedure as an emergency measure to Open it: 1. Remove the cap on the interior surface of the liftgate with a flathead sc ...

Rear Heat Duct Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Decoration panel. b. Shift lever knob (MTX). c. Front console box. d. Shift panel. e. Upper panel. f. Rear console. g. Side wall. h. Front console. i. Front scuff plate. j. Front side trim. k. Joint ...

Global Positioning System (Gps) Antenna
Purpose, Function The GPS antenna receives signals sent from GPS satellites and sends them to the car navigation unit. NOTE: GPS (Global Positioning System) was developed by the Pentagon (U.S.A.) as an object locating system using satellites. The GPS antenna receives signa ...