CAUTION:
There are two types of PCM settings. If the incorrect PCM is installed, it could cause interference with engine control.
When replacing the PCM, verify the first four digits of the part number indicated on the PCM label before replacement, and replace the PCM with one having the same part number.
1. Disconnect the negative battery cable..
2. Remove the PCM cover..
3. Disconnect the PCM connector..
4. Remove the PCM assembly from the battery tray.
5. Remove the PCM from the PCM bracket.
6. Install in the reverse order of removal.
7. When replacing the PCM on the vehicles, perform the following:
PCM configuration.
NOTE:
If configuration cannot be performed by reading/writing of the vehicle specification information, perform the configuration using As-Built information after replacing the PCM..
Immobilizer system-related parts programming.
PCM Cover Installation Note
1. Insert the PCM cover end into area A shown in the figure.
2. Temporarily tighten the two bolts, then completely tighten them.
PCM Connector Connection Note
CAUTION:
Do not touch the PCM connector terminal. The terminal is extremely thin and can be damaged by touching it.
If the PCM connector is inserted at an angle and the lever is moved, the connector could be damaged. Verify that the PCM connector is inserted straight.
1. Set the PCM connector to the position shown in the figure.
2. Align the PCM connector straight against the connection surface.
3. Insert the PCM connector straight and press it in until the lever moves up naturally. (Front harness-side connector)
4. Press the PCM connector lever until a click sound is heard.
Center Pillar Removal [Panel Replacement]
Symbol Mark
Removal Procedure
CAUTION:
Remove the curtain air bag module to prevent damage before servicing.
Front-side
Rear-side
CAUTION:
Avoid cutting with a blowtorch or similar tools as the insulator (shaded
area) is flammable.
1. Rough cut the ...
Rear Wheel Hub Bolt Replacement
1. Remove the brake calliper component and suspend it out of the way using a
cable.
2. Remove the disc plate.
3. Remove the wheel hub bolt using the SST as shown in the figure.
4. Place a new wheel hub bolt in the wheel hub.
5. Install the wheel hub by placing a proper sized washer o ...
Master Warning Light
Purpose
The master warning light warns the driver that any of the following malfunctions
is occurring.
Brake switch malfunction
Engine oil solenoid valve malfunction
Automatic configuration malfunction
Function
The instrument cluster i ...