Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Passenger Side Air Bag Module [Two Step Deployment Control System]

Mazda CX-5 Service & Repair Manual / Engine / Control / Passenger Side Air Bag Module [Two Step Deployment Control System]

Purpose

Function


Construction

Operation

Inflator No.1

1. When the driver-side air bag module receives an operation (deployment) signal from the SAS control module, the igniter built into inflator No.1 builds up heat and ignites the inflammation agent.


2. The ignition of the inflammation agent causes the combustion of a gas-generating agent which releases nitrogen gas.

3. The nitrogen gas is cooled at the filter and the filtrate is injected into the air bag.

Inflator No.2

1. When the driver-side air bag module receives an operation (deployment) signal from the SAS control module, the igniter built into inflator No.2 builds up heat and ignites the inflammation agent.


2. The ignition of the inflammation agent causes the combustion of a gas-generating agent which releases nitrogen gas.

3. The nitrogen gas is cooled at the filter and the filtrate is injected into the air bag.

Fail-safe

Passenger Side Air Bag Module [Standard Deployment Control System]
Purpose When the passenger-side air bag module receives an impact from a frontal or frontal offset collision, the operation (deployment) of the air bag mediates the impact to the head and ...

Pre Tensioner Seat Belt [Standard Deployment Control System]
Purpose The pre-tensioner seat belt retracts and tightens the seat belt webbing to protect the front passengers during a collision. Function The pre-tensioner seat belts operate ...

Other materials:

Rear Side Frame Removal [Panel Replacement]
Symbol Mark Removal Procedure NOTE: When drilling the 35 locations indicated by (A) and 4 locations indicated by (C) shown in the figure, do not drill a hole all the way through or there could be a problem when installing the new part. 1. Drill the 35 locations indicated by ...

Refrigerant Line
Purpose The system piping connects each related part of the refrigerant system. Construction Block-type piping has been adopted to the pipe connection, improving the efficiency of piping related servicing. The pipes in the piping system consist of the following parts. ...

License Plate Light Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Liftgate upper trim. b. Liftgate side trim. c. Liftgate lower trim. 3. Disconnect the connector. 4. While pressing the license plate light tab in the direction of arrow (1) shown in the figure, press the l ...

© 2016-2022 Copyright www.mcx5.org