Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Passenger Side Air Bag Module Removal/Installation [Two Step Deployment Control System]

Mazda CX-5 Service & Repair Manual / Engine / Control / Passenger Side Air Bag Module Removal/Installation [Two Step Deployment Control System]

WARNING:

NOTE:

1. Switch the ignition to off.

2. Disconnect the negative battery cable and wait for 1 min or more

..

3. Remove the following parts:

a. Front scuff plate (passenger-side).

b. Front side trim (passenger-side).

c. Glove compartment.

d. Decoration panel.

e. Dashboard under cover.

f. Lower panel (passenger-side).

g. Front heat duct (passenger-side).

h. Blower unit.

4. Disconnect the connector.


5. Remove clips A.


6. Remove clip B while opening the tabs outward using snap ring pliers.

7. Remove the nuts.


8. Remove the bracket.

9. Remove screws A and B while visually verifying the screw positions..


10. Pull the passenger-side air bag module in the direction of the arrow (2) and remove hooks A from the dashboard while spreading the dashboard in the direction of the arrow (1).


11. Move the passenger-side air bag module in the direction of the arrow (3) and detach hooks B from the dashboard.

12. Set the passenger-side air bag module bracket aside from the dashboard duct (5) while sliding the passenger-side air bag module in the direction of the arrow (4).


13. Remove the passenger-side air bag module.


14. Install in the reverse order of removal.

15. Switch the ignition ON (engine off or on).

16. Verify that the air bag system warning light illuminates for approx. 6 s

and goes out.

Screw Installation Note

NOTE:

1. Insert a phillips screwdriver into the screw groove and fix it with packing tape.


2. Tighten the screw halfway.

3. Remove the packing tape.

CAUTION:

4. Tighten the screw completely.

Passenger Side Air Bag Module Removal/Installation [Standard Deployment Control System]
WARNING: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before h ...

Passenger Side Air Bag Module [Standard Deployment Control System]
Purpose When the passenger-side air bag module receives an impact from a frontal or frontal offset collision, the operation (deployment) of the air bag mediates the impact to the head and ...

Other materials:

Clutch Fluid Replacement/Air Bleeding [C66 M R]
CAUTION: Do not allow clutch fluid to get on a painted surface. Clutch fluid contains properties which can dissolve the paint. If clutch fluid gets on a painted surface, wash it off with water immediately and wipe the area off completely. Do not mix different types of clutch fl ...

Rear Buckle Removal/Installation
1. Switch the ignition to off. 2. Disconnect the negative battery cable and wait for 1 min or more.. 3. Press the release switch, then disconnect the rear center seat belt and rear buckle. 4. Fold down the rear seat back. 5. Remove the trunk board.. 6. Remove the bolt. 7. Remo ...

Accelerator Pedal Position (App) Sensor
Purpose/Function Detects the accelerator pedal depression amount as basic information for mainly determining the throttle valve opening. Detects the accelerator pedal depression amount and inputs it to the PCM as an accelerator pedal opening angle signal. Construction ...

© 2016-2022 Copyright www.mcx5.org