Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Passenger Side Air Bag Module Removal/Installation [Standard Deployment Control System]

Mazda CX-5 Service & Repair Manual / Engine / Control / Passenger Side Air Bag Module Removal/Installation [Standard Deployment Control System]

WARNING:

NOTE:

1. Switch the ignition to off.

2. Disconnect the negative battery cable and wait for 1 min or more

..

3. Remove the following parts:

a. Front scuff plate (passenger-side).

b. Front side trim (passenger-side).

c. Glove compartment.

d. Decoration panel.

e. Dashboard under cover.

f. Lower panel (passenger-side).

g. Front heat duct (passenger-side).

h. Blower unit.

4. Disconnect the connector.


5. Remove clips A.


6. Remove clip B while opening the tabs outward using snap ring pliers.

7. Remove the nuts.


8. Remove the bracket.

9. Remove screws A and B while visually verifying the screw positions..


10. Pull the passenger-side air bag module in the direction of the arrow (2) and remove hooks A from the dashboard while spreading the dashboard in the direction of the arrow (1).


11. Move the passenger-side air bag module in the direction of the arrow (3) and detach hooks B from the dashboard.

12. Set the passenger-side air bag module bracket aside from the dashboard duct (5) while sliding the passenger-side air bag module in the direction of the arrow (4).


13. Remove the passenger-side air bag module.


14. Install in the reverse order of removal.

15. Switch the ignition ON (engine off or on).

16. Verify that the air bag system warning light illuminates for approx. 6 s

and goes out.

Screw Installation Note

NOTE:

1. Insert a phillips screwdriver into the screw groove and fix it with packing tape.


2. Tighten the screw halfway.

3. Remove the packing tape.

CAUTION:

4. Tighten the screw completely.

Passenger Sensing System [Two Step Deployment Control System]
Purpose The passenger sensing system detects whether or not there is an occupant on the passenger seat to control the operation (deployment) of the passenger-side air bag system correspon ...

Passenger Side Air Bag Module Removal/Installation [Two Step Deployment Control System]
WARNING: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before h ...

Other materials:

Blind Spot Monitoring (Bsm) Control Module Inspection
1. Disconnect the negative battery cable.. 2. Remove the rear combination light.. 3. Remove the rear bumper.. 4. Connect the negative battery cable.. 5. Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference). If the voltage is n ...

Starter Interlock Switch [Skyactiv G 2.0]
Purpose, Function The starter interlock switch mechanism prevents vehicle surge when the engine is started, enhancing safety. The engine cannot be started unless the clutch is depressed. Construction The mechanism is provided with a starter interlock switch on the circuit ...

Keyless Antenna [Keyless Entry System]
Purpose Outputs a request signal and specifies the remote transmitter location. Function The keyless antennas output request signals based on the signals from the start stop unit. Construction, Operation Request signals are output by the keyless antenna installed ...

© 2016-2022 Copyright www.mcx5.org