1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate (driver-side).
b. Front side trim (driver-side).
c. Switch panel.
d. Decoration panel.
e. Shift lever knob (MTX).
f. Front console box.
g. Shift panel.
h. Upper panel.
i. Rear console.
j. Side wall.
k. Front console.
l. Hood release lever from the lower panel.
m. Lower panel (driver-side).
3. Remove the aspirator..
4. Remove the screw.
5. Disconnect the connector.
6. Remove the passenger compartment temperature sensor.
7. Install in the reverse order of removal.
Aspirator Removal Note
1. Remove the aspirator as shown in the figure.
Down Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The down switch detects the shift down operation of the selector lever.
The down switch signal is sent to the TCM via CAN and is used for manual
shift control and engine-transaxle integration control.
Construction
The down switch is installed to the se ...
Parking Mechanism [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The parking mechanism locks the output gear when the selector lever is shifted
to the P position which locks the driving wheels against rotation to prevent
coasting when parking the vehicle.
Construction/Operation
For component parts related to the parking ...
Air Bag System Warning Alarm [Standard Deployment Control System]
Purpose
The air bag system warning alarm notifies the driver that a malfunction occurred
in the air bag system instead of the air bag system warning light.
Function
If a malfunction occurs in the air bag system while the air bag system warning
light cannot illuminate, the a ...