Mazda CX-5 Service & Repair Manual: Parking Brake Lever Inspection
Stroke Inspection
1. Pump the brake pedal a few times.
2. Pull the parking brake lever two to three times.
3. Inspect the parking brake stroke by slowly pulling at point A 50 mm {2.0 in}
from the end of the parking brake lever with a force of 98 N {10 kgf, 22 lbf}
and counting the number of notches (clicking sound).
-
If not within the specification, adjust the parking brake lever.
-
Parking brake lever stroke when pulled at 98 N {10 kgf, 22 lbf}
-
2—3 notches
Parking Brake Lever Adjustment
1. Pump the brake pedal a few times.
2. Remove the upper console and put it out of the way..
3. Turn the adjusting nut and adjust the parking brake lever.
4. After adjustment, pull the parki ...
Parking Brake Lever Removal/Installation
1. Remove the front console box..
2. Remove the shift lever knob. (MTX).
3. Remove the shift panel..
4. Remove the upper panel..
5. Remove in the order indicated in the table.
6. Install in ...
Other materials:
Sae Standards
In accordance with new regulations, SAE (Society of Automotive Engineers)
standard names and abbreviations are now used in this manual. The table below
lists the names and abbreviations that have been used in Mazda manuals up to
now and their SAE equivalents.
...
Wiper Blades
CAUTION
●Hot waxes applied by automatic car washers
have been known to affect the wiper's ability to clean windows.
● To prevent damage to the wiper blades,
do not use gasoline, kerosene, paint thinner, or other solvents on or near them.
● When the wiper lever is in the ...
Antenna Feeder No.1 Inspection
With audio system
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. A-pillar trim (RH).
b. Decoration panel.
c. Audio unit.
3. Disconnect antenna feeder No.2.
4. Verify that the continuity between antenna feeder No.1 terminals is as indicated
in the tabl ...
