Chevrolet Spark manuals

Mazda CX-5 Owners Manual: Operating Tips

Operate the climate control system with the engine running.

To prevent the battery from being discharged, do not leave the fan control dial on for a long period of time with the ignition switched ON when the engine is not running.

Clear all obstructions such as leaves, snow and ice from the hood and the air inlet in the cowl grille to improve the system efficiency.

Use the climate control system to defog the windows and dehumidify the air.

The recirculate mode should be used when driving through tunnels or while in a traffic jam, or when you would like to shut off outside air for quick cooling of the interior.

Use the outside air mode for ventilation or windshield defrosting.

If the vehicle has been parked in direct sunlight during hot weather, open the windows to let warm air escape, then run the climate control system.

Run the air conditioner about 10 minutes at least once a month to keep internal parts lubricated.

Have the air conditioner checked before the weather gets hot. Lack of refrigerant may make the air conditioner less efficient.

The refrigerant specifications are indicated on a label attached to the inside of the engine compartment.

Check the label before refilling the refrigerant. If the wrong type of refrigerant is used, it could result in a serious malfunction of the air conditioner.

For details, consult an Authorized Mazda Dealer.


Climate Control System
...

Vent Operation
Adjusting the Vents Directing airflow To adjust the direction of airflow, move the adjustment knob. NOTE hen using the air conditioner under humid ambient temperature conditions, the system may ...

Other materials:

Back Up Light Switch Removal/Installation [C66 M R]
1. Disconnect the negative battery cable.. 2. Remove the front under cover No.2.. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. 1 Back-up light switch connector 2 Back-up light switch ...

Inspection Of SST (Deployment Tool) [Standard Deployment Control System]
1. Before using the SST (49 H066 002), inspect its operation. Inspection Procedure 1. Follow the steps below to inspect the SST (49 H066 002). If not as indicated in the table, replace the SST (49 H066 002) because it has a malfunction. WARNING: Do not use a malfu ...

Headliner
Purpose/Function The headliner is equipped with a shock absorbing pad for driver's head protection during a collision. Construction The front and rear side of the headliner is equipped with a shock absorbing pad with a plastic rib-pad structure. ...

© 2016-2022 Copyright www.mcx5.org