Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: On/Off Solenoid Removal/Installation [Fw6 A EL, Fw6 Ax EL]

Mazda CX-5 Service & Repair Manual / Drivetrain / Transmission/Transaxle / Automatic / On/Off Solenoid Removal/Installation [Fw6 A EL, Fw6 Ax EL]

WARNING:

1. Disconnect the negative battery cable..

2. Remove the front under cover No.2..

3. Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.

4. Drain the ATF..

5. Remove the oil pan.

CAUTION:

6. Disconnect the ON/OFF solenoid connector.

NOTE:


7. Remove the ON/OFF solenoid.


8. Install the ON/OFF solenoid.


9. Connect the ON/OFF solenoid connector.


10. Apply a light coat of silicon sealant (TB1217E) to the contact surfaces of the oil pan and transaxle case.


CAUTION:

11. Install the oil pan with new bolts before the applied sealant starts to harden.

12. Install the front under cover No.2..

13. Add the ATF..

14. Connect the negative battery cable..

15. Perform the “Mechanical System Test”..

Oil Seal (Control Valve Body) Replacement [Fw6 A EL, Fw6 Ax EL]
1. Disconnect the negative battery cable.. 2. Remove the air cleaner component.. 3. Disconnect the control valve body connector. CAUTION: Make sure that your hand does not touch the ...

On/Off Solenoid [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The on/off solenoid performs switching of the shift valve in the control valve body according to the vehicle conditions. Construction The on/off solenoid is ins ...

Other materials:

Front Sash Molding Installation
WARNING: Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife. NOTE: Double-sided adhesive tape has already been attached to the new front sash molding. 1. When installing a new front sash molding, follow the procedur ...

Hydraulic Pressure Control System Outline [Fw6 A EL, Fw6 Ax EL]
Outline The hydraulic control mechanism consists of an oil cooler which maintains the hydraulic pressure at the optimum temperature, a control valve body and each shift valve which perform adjustment and circuit switching of the hydraulic pressure based on the control content calcula ...

Rear Wiper Motor Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Rear wiper arm and blade. b. Liftgate upper trim. c. Liftgate side trim. d. Liftgate recess. e. Liftgate lower trim. 3. Remove the rear wiper motor connector. 4. Remove bolts shown in the figure. 5 ...

© 2016-2024 Copyright www.mcx5.org