Mazda CX-5 Service & Repair Manual: On Board Diagnostic System Simulation Inspection [Fw6 A EL, Fw6 Ax EL]

Mazda CX-5 Service & Repair Manual / Electrical / Data Network / On Board Diagnostic System Simulation Inspection [Fw6 A EL, Fw6 Ax EL]

1. Connect the M-MDS to the DLC-2.

2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

a. Select “DataLogger”.

b. Select “Modules”.

c. Select “TCM”.

3. Select the simulation items from the PID table.

4. Perform the active command modes function, inspect the operations for each parts.

If the operation of output parts cannot be verified after the active command mode inspection is performed, this could indicate the possibility of an open or short circuit, sticking, or operation malfunction in the output parts.

Simulation item table


Item	Description	Unit/Condition	Operation condition
SS_ON-OFF	On/off solenoid condition	Off/On	Under the following conditions: Vehicle stopped Idling at P or N position
SS1_C	Shift solenoid No.1 target current	A	Under the following conditions: Vehicle stopped Idling at P or N position
SS2_C	Shift solenoid No.2 target current	A	Under the following conditions: Vehicle stopped Idling at P or N position
SS3_C	Shift solenoid No.3 target current	A	Under the following conditions: Vehicle stopped Idling at P or N position
SS4_C	Shift solenoid No.4 target current	A	Under the following conditions: Vehicle stopped Idling at P or N position
SSLU_C	TCC control solenoid target current	A	Under the following conditions: ATF temperature (PID: TFT) is 20 °C {68 °F} or more. Output shaft speed (PID: OSS) is 10 rpm or more. Turbine/input shaft speed (PID: TSS) is 1,000 rpm or more. Brake pedal released
SSP_C	Pressure control solenoid target current	A	Idling at P or N position

On Board Diagnostic System PID/Data Monitor Inspection [Fw6 A EL, Fw6 Ax EL]

1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modules� ...

PID/Data Monitor Inspection [Front Body Control Module (Fbcm)]

1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modules� ...

Other materials:

Remote Transmitter Battery Voltage Inspection
NOTE: Because the remote transmitter battery power cannot be determined using the battery itself, determine by the remote transmitter battery low warning operation conditions. Operation procedure for remote transmitter battery low warning 1. Place the remote transmitter inside t ...

Electric Variable Valve Timing Control
Outline The PCM determines the optimum intake valve timing according to the engine operation conditions, and sends the motor drive signals to the electric variable valve timing driver. With the adoption of the electric drive system, variable intake valve timing can be controlled with ...

Forced Ignition On
NOTE: In order to perform a forced ignition ON, the M-MDS is necessary. If the servicing is being done outside of an Authorized Mazda dealership, contact an Authorized Mazda dealership for instructions. The forced ignition ON procedure forces a power supply to each part when ...