1. Remove the drain plug and the drain differential oil into a container.
2. Install a new washer and the drain plug, and tighten.
3. Remove the rear drive shaft..
4. Remove the clip from the drive shaft.
CAUTION:
Wrap the end of a screwdriver with cloth to prevent scratches to the inside of the differential casing.
5. Remove the oil seal from the differential casing using a screwdriver.
6. Apply differential oil to the new oil seal lip.
NOTE:
Install the oil seal at a straight angle.
7. Install the new oil seal to the differential carrier using the SST
.
8. After installing the new clip onto the drive shaft, insert the drive shaft into the differential..
9. Verify that the drive shaft cannot be pulled out.
10. Add the specified differential oil.
11. After adding the oil, perform an oil level inspection..
12. Install a new washer and the oil filler plug, and tighten.
40—53 N·m {4.1—5.4 kgf·m, 30—39 ft·lbf}
Clutch Pedal Position Switch Removal/Installation [C66 M R]
1. Disconnect the negative battery cable..
2. Disconnect the clutch pedal position switch connector.
3. Rotate the clutch pedal position switch 45° counterclockwise.
4. Remove the clutch pedal position switch from the clutch pedal.
5. Insert a new clutch pedal position switch into t ...
Hood Latch Switch Inspection
1. Disconnect the negative battery cable..
2. Remove the front bumper..
3. Disconnect the hood latch switch connector..
4. Verify that the continuity is as indicated in the table.
NOTE:
Inspect the continuity when the hood is open and closed.
If the operation as i ...
Fuel Gauge Sender Unit Removal/Installation [Awd]
WARNING:
Always keep sparks and flames away from fuel when servicing the fuel system.
Fuel can be easily ignited which could cause serious injury or death, and damage
to equipment.
Fuel line spills and leakage from the pressurized fuel system are dangerous.
Fuel can ignite a ...