1. Remove the front under cover No.2..
2. Drain the manual transaxle oil..
3. Disconnect the drive shaft (LH) from the MTX..
4. Disconnect the drive shaft (RH) from the MTX..
5. Remove the oil seal (LH).
6. Remove the oil seal (RH).
7. Using the SST
s and a hammer, tap a new oil seal (LH) in evenly until the SST
s contacts the transaxle case.
8. Using the SST
s and a hammer, tap a new oil seal (RH) in evenly until the SST
s contacts the transaxle case.
9. Coat the lip of each oil seal with transaxle oil.
10. Install in the reverse order of removal.
11. Add the specified amount of specified transaxle oil..
Air Bag System Warning Light [Standard Deployment Control System]
Purpose
The air bag system warning light notifies the driver of a malfunction in
the SRS air bag system.
Function
If a malfunction occurs in the SRS air bag system, the air bag system warning
light illuminates or flashes.
Construction
LEDs (light-emitting d ...
Fuel and Engine Exhaust Precautions
Fuel Requirements
Vehicles with catalytic converters or oxygen sensors must use ONLY UNLEADED FUEL,
which will reduce exhaust emissions and keep spark plug fouling to a minimum.
Your Mazda will perform best with fuel listed in the table.
Fuel with a rating lower than 87 octane (91 RON) could ...
Condenser
Purpose
The condenser cools the high-temperature, highly pressurized refrigerant.
Function
The condenser cools the high-temperature, highly pressurized gaseous refrigerant
compressed by the A/C compressor using the outside air, and changes it to liquid
refrigerant.
Co ...