Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Oil Seal (Control Valve Body) Replacement [Fw6 A EL, Fw6 Ax EL]

Mazda CX-5 Service & Repair Manual / Drivetrain / Transmission/Transaxle / Automatic / Oil Seal (Control Valve Body) Replacement [Fw6 A EL, Fw6 Ax EL]

1. Disconnect the negative battery cable..

2. Remove the air cleaner component..

3. Disconnect the control valve body connector.


CAUTION:

4. Remove the hose clamp.


5. Cut the oil seal using a utility knife as shown in the following illustration.


CAUTION:

6. Using a tape-wrapped flathead screwdriver, remove the oil seal from the transaxle case.


NOTE:

7. Temporarily install the oil seal (control valve body) by hand.

8. Using the SSTs

and a hammer, install the oil seal (control valve body) so that it is not tilted and there is no height difference between the transaxle case surface and the end surface of the oil seal.


CAUTION:

9. Install a new hose clamp to the position shown in the figure.

CAUTION:

10. Connect the control valve body connector.

CAUTION:


11. Install the air cleaner component..

12. Connect the negative battery cable..

Oil Pump [Skyactiv G 2.0]
Outline The oil pump has a mechanism for feedback control of oil pressure. As a result, an oil pressure increase of more than the set pressure is suppressed and oil pump drive resistance ...

On/Off Solenoid Removal/Installation [Fw6 A EL, Fw6 Ax EL]
WARNING: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool. Always wear protective eye wear when using the air compressor. If the ...

Other materials:

Shift Position Indicator Light [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The shift position indicator light indicates the selector lever position. Construction The shift position indicator light is built into the instrument cluster. Operation The TCM sends a shift position indicator light illumination request signal ...

Check Valve Removal/Installation
Except U.S.A. And CANADA 1. Remove the floor under cover.. 2. Remove in the order indicated in the table. 1 Evaporative hose 2 Check valve 3. Install in the reverse order of removal. ...

Side Air Bag Module Removal/Installation [Standard Deployment Control System]
WARNING: Handling the air bag module improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module.. If the side air bag module is installed with debris i ...

© 2016-2024 Copyright www.mcx5.org