Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Oil Pump Removal/Installation

Mazda CX-5 Service & Repair Manual / Engine / Lubrication / Oil Pump Removal/Installation

WARNING:

CAUTION:

NOTE:

1. Disconnect the negative battery cable..

2. Remove the plug hole plate..

3. Remove the ignition coil/ion sensors..

4. Remove the front under cover No.2..

5. Remove the splash shield..

6. Remove the drive belt..

7. Drain the engine oil..

8. Remove the oil pan..

9. Remove the engine front cover..

10. Remove in the order indicated in the table.

11. Install in the reverse order of removal.

12. Refill with the specified type and amount of the engine oil..

13. Start the engine and confirm that there is no oil leakage.

14. Inspect the oil level..

15. Inspect for the ignition timing and idle speed..

16. Inspect the oil pressure..



1

Oil strainer

2

Oil pump chain tensioner

3

Oil pump driven sprocket

(See Oil Pump Driven Sprocket Removal Note.)

(See Oil Pump Driven Sprocket Installation Note.)

4

Oil pump

(See Oil Pump Installation Note.)


Oil Pump Driven Sprocket Removal Note

1. Temporarily assemble the crankshaft pulley lock bolt, and lock the oil pump against rotation as shown in the figure.


2. Remove the oil pump driven sprocket.

Oil Pump Installation Note

1. Install the oil pump using the following procedure:

a. Temporarily tighten the three bolts

shown in the figure.


b. Tighten the two bolts

shown in the figure to the specified torque.


NOTE:

c. Finally, tighten the bolt shown in the figure to the specified torque.


Oil Pump Driven Sprocket Installation Note

1. Temporarily assemble the crankshaft pulley lock bolt, and lock the oil pump against rotation as shown in the figure.


2. Install the oil pump driven sprocket.

3. Remove the temporarily assembled crankshaft pulley lock bolt.

Oil Pressure Inspection
WARNING: Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled. A vehicle that is lifted but not securely supported ...

Oil Pump [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The oil pump generates hydraulic pressure in the oil line of the automatic transaxle together with supplying lubrication to powertrain related parts. Construction ...

Other materials:

Cargo Compartment Light Inspection
1. Disconnect the negative battery cable.. 2. Remove the cargo compartment light.. 3. Verify that the continuity between the cargo compartment light terminals is as indicated in the table. If not as indicated in the table, replace the cargo compartment light.. ...

Parking in an Emergency
Parking in an Emergency The hazard warning lights should always be used when you stop on or near a roadway in an emergency. The hazard warning lights warn other drivers that your vehicle is a traffic hazard and that they must take extreme caution when near it. Depress the hazard warning fla ...

Clutch Fluid Inspection [C66 M R]
NOTE: A common reserve tank is used for the clutch system and brake system. 1. Verify that the clutch fluid is between the MIN mark and the MAX mark. Verify that there is no clutch fluid leakage then add clutch fluid to the level between the MIN mark and the MAX mark.. ...

© 2016-2025 Copyright www.mcx5.org