Mazda CX-5 Service & Repair Manual: Oil Pressure Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
-
The oil pressure switch detects the engagement pressures of the low clutch, 2-6 brake, R-3-5 brake, and the high clutch.
-
The oil pressure switch signal is used for automatic shift control, manual shift control, TCC control, line pressure control, direct electric shift control, and the on-board diagnostic system.
Construction
-
The oil pressure switch contacts the oil passages of the low clutch, 2-6 brake, R-3-5 brake, and the high clutch and is installed to the control valve body.
-
The oil pressure switch is an on/off type switch.
|
Oil pressure switch |
Clutch/brake |
|
|
Oil pressure switch A |
Oil pressure switch No.2 |
2-6 brake |
|
Oil pressure switch No.3 |
R-3-5 brake |
|
|
Oil pressure switch B |
Oil pressure switch No.1 |
Low clutch |
|
Oil pressure switch No.4 |
High clutch |
|
Operation
-
When engagement pressure is supplied to the applicable clutch and brake, the oil pressure switch contact point closes.
-
The TCM detects that clutch engagement pressure is supplied to the applicable clutch/brake by opening/closing the oil pressure switch contact point.
|
Oil pressure switch |
1GR |
2GR |
3GR |
4GR |
5GR |
6GR |
|
Oil pressure switch No.1 |
X |
X |
X |
X |
||
|
Oil pressure switch No.2 |
X |
X |
||||
|
Oil pressure switch No.3 |
X |
X |
||||
|
Oil pressure switch No.4 |
X |
X |
X |
Oil Pressure Switch Removal/Installation [Fw6 A EL, Fw6 Ax EL]
WARNING:
A hot transaxle and ATF can cause severe burns. Turn off the engine and wait
until they are cool.
Always wear protective eye wear when using the air compressor. If the ...
HVAC
...
Other materials:
Camshaft Position (CMP) Sensor
Purpose/Function
Detects the camshaft speed as basic information for mainly determining the
fuel injection timing and ignition timing.
Detects the camshaft speed and inputs it to the PCM as a CMP signal.
Construction
Intake CMP sensor
Installed on the cylinder head.
...
Rear Seat Back Removal/Installation
CAUTION:
When removing or putting in the rear seat, contact with the surrounding areas
of the vehicle could cause scratches and damage. When removing or putting in
the rear seat, always use two or more persons to perform the work and be careful
not to scratch or damage the rear seat ...
Oil Strainer
Purpose, Function
The oil strainer suctions the engine oil in the oil pan using the oil pump
vacuum. The engine oil is filtered by the internal filter at that time.
Construction
The oil strainer is installed on the suction port of the oil pump.
The oil strain ...
