WARNING:
Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled.
A vehicle that is lifted but not securely supported on safety stands is dangerous. It can slip or fall, causing death or serious injury. Never work around or under a lifted vehicle if it is not securely supported on safety stands.
Continuous exposure to USED engine oil has caused skin cancer in laboratory mice. Protect your skin by washing with soap and water immediately after working with engine oil.
1. Disconnect the negative battery cable..
2. Remove the front under cover No.2..
3. Remove the oil pressure switch..
NOTE:
Use the following SSTs in this inspection.
49 D019 908 (gauge)
49 D019 909 (hose)
49 D019 910 (adapter)
49 D019 911 (adapter)
4. Install the SSTs
to the oil pressure switch installation hole using the following procedure.
a. Assemble SSTs 49 D019 908
, 49 D019 909
, and 49 D019 911
outside of the engine compartment beforehand.
b. Install SST 49 D019 910
to the oil pressure switch installation hole.
c. Install SST 49 D019 911
to the SST 49 D019 910
.
5. Connect the negative battery cable..
6. Warm up the engine to normal operating temperature.
7. Run the engine at the specified speed, and note the gauge readings.
If not within the specification, inspect for the cause and repair or replace if necessary.
NOTE:
The oil pressure can vary with oil viscosity, temperature and engine speed.
Lo : 110—175 kPa {1.13—1.78 kgf/cm2, 16.0—25.3 psi} [1,500 rpm]
Hi : 300—430 kPa {3.06—4.38 kgf/cm2, 43.6—62.3 psi} [4,500 rpm]
8. Stop the engine and wait until it is cools.
9. Disconnect the negative battery cable..
10. Remove the SSTs.
11. Install the oil pressure switch..
12. Connect the negative battery cable..
13. Start the engine and confirm that there is no oil leakage.
If there is oil leakage, repair or replace the applicable part.
14. Install the front under cover No.2..
Rear Console Disassembly/Assembly
1. Disassemble in the order indicated in the table.
1
Screw A
2
Rear console bracket
3
Screw B
4
Side panel
5
Rear console box
6
U ...
TCM [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The TCM detects the vehicle conditions and performs calculations and processing
based on input information from each type of sensor and switch.
Outputs control signals to each solenoid valve so that each type of control
is optimally implemented according to the ...
Automatic Transaxle Warning Light [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The automatic transaxle warning light illuminates when the transaxle has
malfunction.
Construction
The automatic transaxle warning light is built into the instrument cluster.
Operation
If the transmission has a malfunction, the TCM sends an ...