Mazda CX-5 Service & Repair Manual: Oil Cooler Removal/Installation [Fw6 A EL, Fw6 Ax EL]

Mazda CX-5 Service & Repair Manual / Engine / Lubrication / Oil Cooler Removal/Installation [Fw6 A EL, Fw6 Ax EL]

1. Disconnect the negative battery cable..

2. Remove the front under cover No.2..

3. Drain the ATF..

4. Drain the engine coolant..

5. Remove in the order indicated in the table.

1	Water hose (connected to the water pipe)
2	Water hose (connected to the outlet)
3	Water-cooled oil cooler
4	O-rings

6. Install in the reverse order of removal.

7. Add the engine coolant..

8. Add the ATF..

9. Perform the “Mechanical System Test”..

Water Hose Installation Note

1. Install the water hose to the oil cooler as shown in the figure with the hose clamp expanded.

NOTE:

A new water hose and hose clamp are attached.

2. Install the hose clamp to the position shown in the figure.

Verify that the installation angle of the hose clamp is within the range shown in the figure.

3. Verify that the hose clamp does not interfere with any other components.

Oil Control Valve (OCV)

Purpose, Function The OCV switches the oil passage to the hydraulic variable valve timing actuator to control the opening/closing period of the exhaust valve. Construction The O ...

Oil Cooler Removal/Installation

WARNING: Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled. A vehicle that is lifted but not securely supported ...

Other materials:

Rear Parking Brake Cable Removal/Installation
1. Remove the front console box.. 2. Remove the shift lever knob. (MTX). 3. Remove the shift panel.. 4. Remove the upper panel.. 5. Remove the rear console.. 6. Loosen the adjusting nut. 7. Remove the floor under cover No.2.. 8. Remove in the order indicated in the table. 9. Install ...

Camshaft Position (CMP) Sensor Removal/Installation
CAUTION: When replacing the CMP sensor, make sure there is no foreign material on it such as metal shavings. If it is installed with foreign material, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration in engine control. ...

Shift Solenoid No.2 [Fw6 A EL, Fw6 Ax EL]
Purpose/Function Shift solenoid No.2 adjusts the hydraulic pressure in the 2-6 brake circuit based on the current demand from the TCM according to the vehicle conditions. Construction Shift solenoid No.2 is installed to the solenoid control valve body. Shift solenoid N ...