Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Oil Control Valve (OCV) [Skyactiv G 2.0]

Mazda CX-5 Service & Repair Manual / Steering / Linkage, Power / Oil Control Valve (OCV) [Skyactiv G 2.0]

Purpose, Function

Construction

Operation

At retard

At advance

Middle point maintenance


Fail-safe


DTC

Fail-safe

P0014:00

  • Performs the exhaust variable valve timing control with a maximum cam retard request.

P0015:00

  • Performs the exhaust variable valve timing control with a maximum cam retard request.

P2090:00

  • Performs the exhaust variable valve timing control with a maximum cam retard request.

P2091:00

  • Performs the exhaust variable valve timing control with a maximum cam retard request.


Oil Control Valve (OCV) Removal/Installation [Skyactiv G 2.0]
WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing. 1. Disconnect the negative battery cable.. 2. Remove the plug hole plat ...

Power Steering Malfunction Indicator Light
Purpose The power steering malfunction indicator light warns the driver that there is a malfunction with the electric power steering (EPS) system. Function If there is a malfunc ...

Other materials:

Pre Tensioner Seat Belt [Standard Deployment Control System]
Purpose The pre-tensioner seat belt retracts and tightens the seat belt webbing to protect the front passengers during a collision. Function The pre-tensioner seat belts operate (deploy) based on the operation signal from the SAS control module to instantly retract and tigh ...

Rear Center Seat Belt Removal/Installation
CAUTION: The ELR (emergency locking retractor) has a spring that will unwind if the retractor cover is removed. The spring cannot be rewound by hand. If this occurs, the ELR will not work properly. Therefore, do not disassemble the retractor. 1. Press the release switch, then dis ...

Mass Air Flow (MAF) Sensor/Intake Air Temperature (Iat) Sensor No.1 Removal/Installation
NOTE: Because the IAT sensor No.1 is integrated in the MAF sensor, replacing the IAT sensor No.1 includes replacement of the MAF sensor/IAT sensor No.1. 1. Disconnect the negative battery cable.. 2. Disconnect the MAF sensor/IAT sensor No.1 connector. 3. Remove the MAF sensor/IA ...

© 2016-2024 Copyright www.mcx5.org