Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Navigation

Tweeter Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the side speaker grille.. 3. Remove the screws. 4. Pull out the tweeter and disconnect the connector. 5. Install in the reverse ord ...

Car Navigation System
Outline The car-navigation system displays point-of-origin and road guidance maps via the audio unit display and provides guidance and information to the desired point of destination. ...

Other materials:

Front Fender Junction Installation [Panel Replacement]
Symbol Mark Installation Procedure 1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions. 2. Drill holes for the plug welding before installing the new parts. 3. After temporarily installing new parts, make sure the related parts fit p ...

Rear Drive Shaft Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel?speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel?speed sensor (wheel side) and fix it to an ap ...

Electrical System
Electrical Parts Battery cable Before disconnecting connectors or removing electrical parts, disconnect the negative battery cable. Wiring Harness To remove the wiring harness from the clip in the engine room, pry up the hook of the clip using a flathead screwdriver. ...

© 2016-2022 Copyright www.mcx5.org