1. Remove the front over fender..
2. Remove screws A.
3. Remove fasteners B.
4. Pull the mudguard in the direction of the arrow shown in the figure.
5. Install in the reverse order of removal.
Condenser Removal/Installation
1. Disconnect the negative battery cable..
2. Discharge the refrigerant..
3. Remove the front under cover No.1..
4. Drain the engine coolant..
5. Remove the following parts:
a. Plug hole plate.
b. Air cleaner, air hose and fresh air duct component.
c. Coolant reserve tank.
d. Cooling ...
Warning Sound is Activated
Lights-On Reminder
If lights are on and the ignition is switched to ACC or the ignition is switched
off, a continuous beep sound will be heard when the driver's door is opened.
NOTE
• When the ignition is switched to ACC,
the “Ignition Not Switched Off (STOP) Warning Beep” ove ...
Brake Fluid Level Sensor Inspection
1. Disconnect the brake fluid level sensor connector from the master cylinder.
2. Inspect for continuity according to fluid level between the brake fluid level
sensor terminals.
If not as indicated in the table, replace the reserve tank..
...