1. Disconnect the negative battery cable..
2. Remove the shift lever using the following procedure:
a. Remove the upper panel..
b. Remove the shift lever knob.
c. Remove the shift panel..
d. Remove the side wall..
e. Remove the rear console..
f. Press the tabs on the control cable as shown in the figure and disconnect the shift lever from the control cable.
g. Disconnect the control cable end from shift lever as shown in the figure.
h. Disconnect the connector from shift lever as shown in the figure.
i. Remove the shift lever.
3. Remove the control cable using the following procedure:
a. Remove the air cleaner component. (ex: air cleaner, air hose).
b. Remove the battery component. (ex: battery, battery tray and PCM component).
c. Remove the control cable end from the MTX.
i. Pull the lock pin in the direction of the arrow shown in the figure and release the control cable end (MTX side) lock.
ii. Remove the control cable end from the MTX.
d. Press the tabs on the control cable and disconnect the control cable from the bracket.
e. Remove the fastening nut for the control cable.
f. Remove the fastening nuts for the grommet.
g. Remove the control cable.
4. Install in the reverse order of removal.
Liftgate Side Trim Removal/Installation
1. Remove the liftgate upper trim..
2. Remove the fastener A.
3. Take the shaded area shown in the figure, and pull the liftgate side trim
in the direction of the arrow (1) while detaching clips B.
4. Take the shaded area shown in the figure, detach tabs C while pulling the
liftgate si ...
Keyless Warning Alarm
Purpose
The keyless warning alarm notifies the driver that the remote transmitter
cannot be verified or the steering lock cannot be released.
Function
When the instrument cluster receives the keyless warning alarm request signal
sent from the start stop unit via the CAN sig ...
Rear Fender Panel Installation [Panel Replacement]
Symbol Mark
Installation Procedure
1. When installing new parts, measure and adjust the body as necessary to conform
with standard dimensions.
2. Drill holes for the plug welding before installing the new parts.
3. After temporarily installing new parts, make sure the related parts fit p ...