Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Manifold Absolute Pressure (Map) Sensor/Intake Air Temperature (Iat) Sensor No.2 Removal/Installation

Mazda CX-5 Service & Repair Manual / Engine / Control / Manifold Absolute Pressure (Map) Sensor/Intake Air Temperature (Iat) Sensor No.2 Removal/Installation

NOTE:

1. Disconnect the negative battery cable..

2. Disconnect the MAP sensor/IAT sensor No.2 connector.

3. Remove the MAP sensor/IAT sensor No.2.


4. Install in the reverse order of removal.

Knock Sensor (Ks)
Purpose/Function Detects abnormal combustion in the cylinder as basic information for mainly determining the ignition timing. Detects abnormal combustion in the combustion chamber an ...

Mass Air Flow (MAF) Sensor/Intake Air Temperature (Iat) Sensor No.1 Removal/Installation
NOTE: Because the IAT sensor No.1 is integrated in the MAF sensor, replacing the IAT sensor No.1 includes replacement of the MAF sensor/IAT sensor No.1. 1. Disconnect the negative bat ...

Other materials:

Cylinder Block
Purpose, Function The cylinder block forms the cylinder and crankcase. Construction The cylinder block consists of the upper cylinder block and lower cylinder block. The cylinder block is an open deck type with excellent cooling performance. The lightweight cyl ...

Antenna Feeder No.1 Inspection
With audio system 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. A-pillar trim (RH). b. Decoration panel. c. Audio unit. 3. Disconnect antenna feeder No.2. 4. Verify that the continuity between antenna feeder No.1 terminals is as indicated in the tabl ...

Rear Bumper Reinforcement Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Rear splash shield. b. Rear combination light. c. Rear bumper. 3. Remove the hanger rubber in the direction of the arrow (1) shown in the figure. 4. Remove nuts. CAUTION: Removing the rear bumper ...

© 2016-2025 Copyright www.mcx5.org