Mazda CX-5 Service & Repair Manual: Manifold Absolute Pressure (Map) Sensor

Mazda CX-5 Service & Repair Manual / Engine / Intake / Manifold Absolute Pressure (Map) Sensor

Purpose/Function

Detects the intake air pressure introduced into the cylinder as basic information for mainly determining the fuel injection amount.
Detects the intake air pressure introduced into the cylinder and inputs it to the PCM as an intake air pressure signal.

Construction

Installed on the intake manifold.
A sealant diaphragm has been adopted as the detecting element for detecting the intake air pressure.
IAT sensor No.2 is integrated.

Operation

Inputs the signal, which fluctuates according to the intake air pressure, to the PCM.

MAP sensor characteristic

Fail-safe


DTC No.	Fail-safe function
P0107:00	Estimates MAP using MAF sensor and engine speed. Restricts the upper limit of the engine speed. Inhibits the evaporative purge control.
P0108:00	Estimates MAP using MAF sensor and engine speed. Restricts the upper limit of the engine speed. Inhibits the evaporative purge control.

Manifold Absolute Pressure (Map) Sensor Inspection

Voltage Inspection 1. Connect the M-MDS to the DLC?2. 2. Switch the ignition ON (engine off or on). 3. Verify that the MAP sensor output voltage (PID: MAP) is within the specification.. ...

Manifold Absolute Pressure (Map) Sensor/Intake Air Temperature (Iat) Sensor No.2 Removal/Installation

NOTE: Because the IAT sensor No.2 is integrated in the MAP sensor, replacing the IAT sensor No.2 includes replacement of the MAP sensor/IAT sensor No.2. 1. Disconnect the negative bat ...

Other materials:

Electric Variable Valve Timing Actuator
Purpose, Function The electric variable valve timing actuator changes the phases of the intake camshaft relative to the crankshaft. As a result, the open/close period of the intake valve is changed, optimized valve timing in accordance with driving conditions is realized, output is i ...

Oil Seal (Differential) Replacement [C66 M R]
1. Remove the front under cover No.2.. 2. Drain the manual transaxle oil.. 3. Disconnect the drive shaft (LH) from the MTX.. 4. Disconnect the drive shaft (RH) from the MTX.. 5. Remove the oil seal (LH). 6. Remove the oil seal (RH). 7. Using the SSTs and a hammer, tap a new oil s ...

Front Body Control Module (Fbcm) Inspection
1. Remove the fuse box cover.. 2. Remove the front body control module (FBCM) from the fuse box.. 3. Verify that the voltages of each of the terminals are as indicated in the Terminal Voltage Table (Reference). If the voltage is not as indicated in the table, inspect the parts under ...