Mazda CX-5 Service & Repair Manual: Magnetic Clutch Disassembly/Assembly [Full Auto Air Conditioner]
1. Disassemble in the order indicated in the table.
|
1 |
Bolt (See Bolt Removal/Installation Note.) |
|
2 |
Pressure plate |
|
3 |
Shim (See Shim Installation Note.) |
|
4 |
Snap ring (See Snap Ring Removal/Installation Note.) |
|
5 |
A/C compressor pulley |
|
6 |
Snap ring (See Snap Ring Removal/Installation Note.) |
|
7 |
Stator |
|
8 |
A/C compressor body |
2. Assemble in the reverse order of disassembly.
3. Adjust the magnetic clutch clearance..
Bolt Removal/Installation Note
1. When removing or installing the bolt, lock the A/C compressor pulley against rotation using the following procedure.
CAUTION:
-
When connecting the positive battery cable to the magnetic clutch connector, use a cable with a female terminal of the correct size. Otherwise, load will be applied to the terminal, resulting in deformation or damage, and poor contact. In addition, the positive battery cable could disconnect from the connector resulting in a short circuit.
a. Apply battery positive voltage to the magnetic clutch terminal and connect the A/C compressor body to the ground.
b. Wrap the drive belt, which is no longer of use, tightly around the A/C compressor pulley.
c. Hold the drive belt in place with pliers.
d. Remove/installation the bolt.
-
Tightening torque
-
10—15 N·m {102 —152 kgf·cm, 89 — 132 in·lbf}
2. When installing a new A/C compressor body, replace the recommended bolt.
Snap Ring Removal/Installation Note
1. Remove/install the snap ring using a snap ring pliers.
Shim Installation Note
1. First, insert the 1mm (0.039 in)
thick shim into the shaft.
Magnetic Clutch Adjustment [Manual Air Conditioner]
1. Measure the clearance around the entire circumference between the pressure
plate and A/C compressor pulley using a thickness gauge.
2. Verify the clearance.
If not within the specif ...
Magnetic Clutch Disassembly/Assembly [Manual Air Conditioner]
1. Disassemble in the order indicated in the table.
1
Bolt
(See Bolt Removal/Installation Note.)
2
Pressure plate
3
...
Other materials:
Troubleshooting
Bluetooth® does not operate under the following conditions. Check whether the
following conditions apply to your Bluetooth® device:
• The device is not being operated correctly.
• The device is not connected to the Bluetooth®
unit equipped on the vehicle.
• The device's battery i ...
Floor Mat
WARNING
Make sure the floor mats are hooked on the retention pins to prevent them from
bunching up under the foot pedals:
Using a floor mat that is not secured is dangerous as it will interfere with
the accelerator and brake pedal operation, which could result in an accident.
Do not install t ...
Planetary Gear [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The planetary gear is a mechanism which shifts the drive force from the engine.
The planetary gear consists of multiple gears which rotate individually while
revolving. By controlling the individual rotation and revolving of the gears,
the transaxle performs gear shi ...
