Mazda CX-5 Service & Repair Manual: M Position Switch Inspection [Fw6 A EL, Fw6 Ax EL]
Continuity Inspection
NOTE:
-
The M position switch is built into the selector lever component.
1. Disconnect the negative battery cable..
2. Remove the front console..
3. Disconnect the selector lever component connector.
4. Verify that the continuity between selector lever component terminals E and J.
-
If not as verified, replace the selector lever component..
|
Test condition |
Continuity |
|
Selector lever is in the M position. |
Continuity |
|
Selector lever is not in the M position. |
No continuity |
Judder Upon Torque Converter Clutch (TCC) Operation [Fw6 A EL, Fw6 Ax EL]
TROUBLESHOOTING ITEM
Judder upon torque converter clutch (TCC) operation
DESCRIPTION
Vehicle jolts when TCC is engaged.
...
M Position Switch Removal/Installation [Fw6 A EL, Fw6 Ax EL]
NOTE:
The M position switch is built into the selector lever component.
1. If the M position switch is replaced, replace the selector lever component..
...
Other materials:
Outer Mirror Glass Removal
1. Disconnect the negative battery cable..
2. Press area A of the outer mirror glass shown in the figure so that area B
moves outward.
3. Put your hand on the lower part of the outer mirror glass and while supporting
the hatch-marked area shown in the figure, remove pin C in the directio ...
Airflow Mode Actuator Inspection [Full Auto Air Conditioner]
CAUTION:
If the lever position exceeds the operation range shown in the figure, the
circuit in the actuator could be damaged. Always perform an actuator operation
inspection with the lever movement within the range shown in the figure.
1. Connect battery positive voltage to airfl ...
Pre Delivery Inspection
Pre?Delivery Inspection Table
Exterior
INSPECT and ADJUST, if necessary, the following items to specification:
?Glass, exterior bright metal and paint for damage
?Wheel lug nuts
?All weatherstrips for damage or detachment
?Adjust tire pressures to specification
Adjust the tire pr ...
