Mazda CX-5 Service & Repair Manual: M Position Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
-
The M position switch detects that the selector lever is in the M position.
-
The M position switch signal is sent to the TCM via CAN, and is used for manual shift control and engine-transaxle integration control.
Construction
-
The M position switch is installed to the selector lever.
-
The M position switch is an on/off type switch.
Operation
-
When the selector lever is in the M position, the M position switch contact point closes.
-
By opening and closing the M position switch contact point, the TCM detects that the selector lever is in the M position.
M Position Switch Removal/Installation [Fw6 A EL, Fw6 Ax EL]
NOTE:
The M position switch is built into the selector lever component.
1. If the M position switch is replaced, replace the selector lever component..
...
Neutral Switch Removal/Installation [C66 M R]
1. Disconnect the negative battery cable..
2. Remove the air cleaner component. (ex: air cleaner, air hose).
3. Remove in the order indicated in the table.
4. Install in the reverse order of rem ...
Other materials:
Side Member Removal [Panel Replacement]
Symbol Mark
Removal Procedure
1. Drill the 45 locations shown in the figure.
NOTE:
When drilling, do not drill a hole all the way through or there could be
a problem when installing the new part.
2. Remove the side member. ...
Variable Valve Timing Mechanism
Outline
Achieves optimum valve timing according to the driving conditions by the
variable valve timing mechanism changing the phases of the camshaft.
An electric type variable valve timing mechanism on the intake side and a
hydraulic pressure type on the exhaust side has been ad ...
Passenger Compartment Temperature Sensor Inspection [Full Auto Air Conditioner]
1. Measure the temperature around the passenger compartment temperature sensor
and measure the resistance between passenger compartment temperature sensor terminals
A and B.
If the characteristics of the passenger compartment temperature sensor are
not as shown in the graph, replace t ...
