Mazda CX-5 Service & Repair Manual: Lubrication System

Mazda CX-5 Service & Repair Manual / Engine / Lubrication / Lubrication System

Outline

Pressure loss is reduced by optimizing the oil passage.
With the adoption of the chain drive type oil pump, oil pump drive force has been reduced.
With the adoption of the oil shower pipe, sliding resistance has been reduced.
With the adoption of the engine oil solenoid valve, oil pump discharge pressure can be controlled (hydraulic two-step control).

Structural View

Flow View

Structure

Consists of the following parts:

Oil filter	(See OIL FILTER [SKYACTIV-G 2.0].)
Oil cooler	(See OIL COOLER [SKYACTIV-G 2.0].)
Oil pan	(See OIL PAN [SKYACTIV-G 2.0].)
Oil strainer	(See OIL STRAINER [SKYACTIV-G 2.0].)
Oil pump	(See OIL PUMP [SKYACTIV-G 2.0].)
Oil jet valve	(See OIL JET VALVE [SKYACTIV-G 2.0].)
Engine oil solenoid valve	(See ENGINE OIL SOLENOID VALVE [SKYACTIV-G 2.0].)
Oil shower pipe	(See OIL SHOWER PIPE [SKYACTIV-G 2.0].)

Front Oil Seal Replacement

WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing. 1. Remove the front under cover No.2.. 2. Remove the splash shield.. ...

Oil Control Valve (OCV) Inspection

Coil Resistance Inspection 1. Disconnect the negative battery cable.. 2. Remove the plug hole plate.. 3. Disconnect the OCV connector. 4. Measure the resistance between terminals A and B using ...

Other materials:

Power Window Subswitch
Purpose Each door glass except for the driver-side can be opened/closed with occupant seated in the cabin using the power window subswitch. Function Manual switch The power window subswitch switches the contact point according to the switch operation and switches the circu ...

Side Sill Panel Removal [Panel Replacement]
Symbol Mark Removal Procedure Side sill (front side) 1. Rough cut the 2 locations indicated by (A) shown in the figure. 2. Drill the 18 locations indicated by (B) shown in the figure. 3. Remove the cabin side outer frame (outer side sill). Side sill (component) 1. Rough cut the 3 l ...

Front Fender Panel Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front bumper. b. Front combination light. c. Front bumper slider. d. Front over fender. 3. Remove bolts A and fasteners B. 4. Remove bolts C. 5. Remove the front fender panel. 6. Install in the reverse ...