Mazda CX-5 Service & Repair Manual: Lubrication
- Engine Oil Control
- Engine Oil Level Inspection
- Engine Oil Pressure Warning Light
- Engine Oil Replacement
- Engine Oil Solenoid Valve Inspection
- Engine Oil Solenoid Valve Removal/Installation
- Engine Oil Solenoid Valve
- Front Oil Seal Replacement
- Lubrication System
- Oil Control Valve (OCV) Inspection
- Oil Control Valve (OCV) Removal/Installation
- Oil Control Valve (OCV)
- Oil Cooler Removal/Installation [Fw6 A EL, Fw6 Ax EL]
- Oil Cooler Removal/Installation
- Oil Cooler [Fw6 A EL, Fw6 Ax EL]
- Oil Cooler
- Oil Filter Replacement
- Oil Filter
- Oil Jet Valve
- Oil Pan Removal/Installation
- Oil Pan
- Oil Pressure Inspection
- Oil Pump Removal/Installation
- Oil Pump [Fw6 A EL, Fw6 Ax EL]
- Oil Pump
- Oil Seal (Control Valve Body) Replacement [Fw6 A EL, Fw6 Ax EL]
- Oil Seal (Coupling Component) Replacement
- Oil Seal (Differential) Replacement [C66 M R]
- Oil Seal (Differential) Replacement [Fw6 A EL, Fw6 Ax EL]
- Oil Seal (Side Gear) Replacement
- Oil Shower Pipe
- Oil Strainer [Fw6 A EL, Fw6 Ax EL]
- Oil Strainer
- Rear Oil Seal Replacement
- Oil Pressure Switch Inspection
- Oil Pressure Switch Removal/Installation [Fw6 A EL, Fw6 Ax EL]
- Oil Pressure Switch [Fw6 A EL, Fw6 Ax EL]
Mass Air Flow (MAF) Sensor/Intake Air Temperature (Iat) Sensor No.1 Removal/Installation
NOTE:
Because the IAT sensor No.1 is integrated in the MAF sensor, replacing the
IAT sensor No.1 includes replacement of the MAF sensor/IAT sensor No.1.
1. Disconnect the negative bat ...
Engine Oil Control
Outline
The PCM reduces the oil pump load applied to the engine by controlling the
appropriate engine hydraulic pressure according to the engine operation conditions.
The engine hydr ...
Other materials:
Front Frame (Rear) Installation [Panel Replacement]
Symbol Mark
Installation Procedure
1. When installing new parts, measure and adjust the body as necessary to conform
with standard dimensions.
2. Drill holes for the plug welding before installing the new parts.
3. After temporarily installing new parts, make sure the related parts fit p ...
Shift Lever [C66 M R]
Purpose, Function
The shift lever operates the MTX via the control cable.
Construction
Shift lever
The shift lever is designed to prevent improper shifting to 1st gear and
reverse.
Operation
1 GR shifting
A guide plate, attached to the shift lever assembly, ...
Audio Pilot®2 Microphone Removal/Installation
NOTE:
AudioPilot®2 is a registered trademark of Bose® Corporation.
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Driver-side front scuff plate.
b. Driver-side front side trim.
c. Switch panel.
d. Decoration panel.
e. Shift lever knob (MTX). ...
