Mazda CX-5 Service & Repair Manual: Linkage, Power
- Electric Power Steering (Eps) Control Module
- Electric Power Steering (Eps) Motor
- Electric Power Steering System
- Eps Control Module Inspection
- Oil Control Valve (OCV) Inspection [Skyactiv G 2.0]
- Oil Control Valve (OCV) Removal/Installation [Skyactiv G 2.0]
- Oil Control Valve (OCV) [Skyactiv G 2.0]
- Power Steering Malfunction Indicator Light
- Pressure Control Valve Inspection [Skyactiv G 2.0]
- Pressure Control Valve [Skyactiv G 2.0]
- Steering Shaft Inspection
- Tie Rod End Inspection
- Tie Rod End Replacement
- Tie Rod Inspection
- Torque Sensor
- Steering Gear And Linkage
- Steering Gear And Linkage Assembly
- Steering Gear And Linkage Disassembly
- Steering Gear And Linkage Inspection
- Steering Gear And Linkage Removal/Installation
Steering Switch Removal/Installation
WARNING:
Handling the driver-side air bag module improperly can accidentally operate
(deploy) the air bag module, which may seriously injure you. Read the service
warnings and cautions b ...
Electric Power Steering (Eps) Control Module
Purpose/ Function
The EPS control module (CM) calculates the optimum assist current based on
the steering torque signal from the torque sensor installed to the steering
column and the veh ...
Other materials:
Sunroof Switch Inspection
1. Disconnect the negative battery cable..
2. Remove the front map light..
3. Verify that the continuity between the sunroof switch terminals is as indicated
in the table.
If not as indicated in the table, replace the sunroof switch.
...
Instrument Cluster Operation Record
Purpose
The instrument cluster operation record stores the record of the illumination
or flashing of the warning light.
Function
The operation record is stored by the instrument cluster and displayed using
the Mazda Modular Diagnostic System (M-MDS).
The instrument ...
Front Drive Shaft Inspection
1. Inspect the connections for any looseness.
If there is any malfunction, tighten or replace the applicable part.
2. Inspect the dust boot for damage and cracks.
If there is any malfunction, replace the applicable part.
3. Move the spline and joint up and down, left ...
