Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Liftgate Opener System

Outline

Function


CAN signal sending module

Signal name

Instrument cluster

Parking brake lever status signal (MTX)

Via instrument cluster from TCM

Selector lever signal (ATX)

Via instrument cluster from PCM

Vehicle speed signal


Structural view


System wiring diagram


Operation

Operation condition


When all of the following conditions are met, the liftgate opener system operates.

Open operation

1. When the liftgate opener switch is pressed, it turns on (1).

2. When the operation condition of the liftgate opener system is met, the rear body control module (RBCM) turns the transistor on for approx. 0.7 s

(2) and turns on the liftgate release relay.

3. When the liftgate release relay turns on, the liftgate lock actuator operates (3).

4. When the liftgate lock actuator operates, the latch lever is freed and the liftgate lifts up simultaneously via the spring force of the liftgate weatherstrip and stopper rubber, and opens.


Liftgate Opener Switch Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Liftgate upper trim. b. Liftgate side trim. c. Liftgate lower trim. d. Liftgate garnish. 3. Remove the liftgate ...

Liftgate Recess Removal/Installation
1. Insert a tape-wrapped flathead screwdriver in the position indicated by the arrow in the figure and detach hooks A. 2. Remove the liftgate recess in the direction of the arrow shown in the ...

Other materials:

Side Step Molding Removal/Installation
1. Set the rear over fender aside.. 2. Insert a tape-wrapped flathead screwdriver shown in the figure and remove the clip A in the direction of arrow (1). 3. Slide the side step molding in the direction of the arrow (2) shown in the figure and remove clips B from side step molding. 4. ...

Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The turbine/input shaft speed sensor detects the rotation speed of the input shaft (low clutch drum). The output shaft speed sensor detects the rotation speed of the output shaft (primary gear). The turbine/input shaft speed sensor and output shaft speed ...

Tcs/DSC Indicator Light
Purpose/Function The TCS/DSC indicator light, built into the instrument cluster, informs the driver of the following vehicle conditions. TCS is operating. (Drive wheel is slipping.) DSC is operating. (Vehicle side-slip condition.) Roll over mitigation (RO ...

© 2016-2022 Copyright www.mcx5.org