Mazda CX-5 Service & Repair Manual: Knock Sensor (Ks) Inspection
Resistance Inspection
1. Remove the KS..
2. Measure the resistance between KS terminals A and B.
-
If not as specified, replace the KS..
-
Specification
-
504—616 kilohms [10—30 °C {50—86 °F}]
Intake Air Temperature (Iat) Sensor
IAT Sensor No.1
Purpose/Function
Detects the IAT before it passes through the throttle body as basic information
for mainly determining the fuel injection amount.
Detects the IAT be ...
Knock Sensor (Ks) Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Remove the intake manifold..
4. Disconnect the KS connector.
5. Remove the KS..
6. Install in the reverse or ...
Other materials:
Awd Control Module Configuration
CAUTION:
When performing configuration, it is necessary to read the coupling component
calibration data from the AWD control module before replacing it. Connect the
M-MDS to the vehicle and perform vehicle identification before removing the
AWD control module. The coupling component ...
Oil Pump
Outline
The oil pump has a mechanism for feedback control of oil pressure. As a result,
an oil pressure increase of more than the set pressure is suppressed and oil
pump drive resistance is reduced. In addition, because the set pressure can
be changed (oil pressure two-step control) ...
Side Air Bag Sensor [Standard Deployment Control System]
Purpose
The side air bag sensor detects an impact during a lateral collision.
Function
The side air bag sensor converts the detected impact to an electrical signal.
Construction
The side air bag sensor is built into the crash sensor.
Two side air bag sensors ...
