Mazda CX-5 Service & Repair Manual: Knock Sensor (Ks)

Mazda CX-5 Service & Repair Manual / Engine / Control / Knock Sensor (Ks)

Purpose/Function

Detects abnormal combustion in the cylinder as basic information for mainly determining the ignition timing.
Detects abnormal combustion in the combustion chamber and inputs it to the PCM as a knocking signal.

Construction

Installed on the cylinder block.
A piezoelectric element has been adopted as the detecting element for detecting abnormal combustion.

Operation

Inputs the signal, which fluctuates according to abnormal combustion, to the PCM.

KS characteristic

Fail-safe


DTC No.	Fail-safe function
P0327:00	Sets the knocking spark retard correction value of the ignition control to the fixed value.
P0328:00	Sets the knocking spark retard correction value of the ignition control to the fixed value.

Knock Sensor (Ks) Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the plug hole plate.. 3. Remove the intake manifold.. 4. Disconnect the KS connector. 5. Remove the KS.. 6. Install in the reverse or ...

Manifold Absolute Pressure (Map) Sensor/Intake Air Temperature (Iat) Sensor No.2 Removal/Installation

NOTE: Because the IAT sensor No.2 is integrated in the MAP sensor, replacing the IAT sensor No.2 includes replacement of the MAP sensor/IAT sensor No.2. 1. Disconnect the negative bat ...

Other materials:

Air Bag System [Two Step Deployment Control System]
Outline The air bag system is a device that supplements the passenger restraint function of the seat belts. The air bag system will not have the designed effect if the seat belts are not worn properly. The air bag system is composed of the following parts: ...

Purge Solenoid Valve Inspection
Airflow Inspection 1. Disconnect the negative battery cable.. 2. Remove the purge solenoid valve.. 3. Inspect airflow between the ports under the following conditions. Measured condition Continuity between ports A—B When voltage is not ...

Antenna Feeder No.2 Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. A-pillar trim (RH). b. Trunk board. c. Trunk end trim (RH). d. Rear scuff plate (RH). e. Trunk side trim (RH). 3. Disconnect antenna feeder No.1. 4. Disconnect antenna feeder No.3. 5. Verify that t ...