Mazda CX-5 Service & Repair Manual: Keyless Antenna [Advanced Keyless Entry System]
Purpose
-
Outputs a request signal and specifies the remote transmitter location.
Function
-
The keyless antenna outputs request signals to the inside and outside of the vehicle based on the signals from the LF control unit.
Construction, Operation
-
The antennas for request signal output form the request signal output range at 5 locations.
Request signal output range
-
The keyless antennas for the vehicle exterior (driver-side, passenger-side, rear) form the request signal output area in the range of an approx. 80 cm {31 in}
radius from each location and communicate with the advanced key.
-
The keyless antennas for the vehicle interior (front, rear) form the output range inside the vehicle.
Fail-safe
-
Function not equipped.
Keyless Antenna Removal/Installation
With Advanced Keyless Entry System
Vehicle interior, front
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Decoration panel.
b. Shift lever knob (MTX).
c. Front ...
Keyless Antenna [Keyless Entry System]
Purpose
Outputs a request signal and specifies the remote transmitter location.
Function
The keyless antennas output request signals based on the signals from the
start stop uni ...
Other materials:
PID/Data Monitor Inspection [Instrument Cluster]
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the M-MDS.
a. Select “DataLogger”.
b. Select “Modules”.
c. Select “IC”.
3. Select the applicable PID from the PID table.
4. Verify the PID dat ...
Tire Pressure Monitoring System Warning Light
Purpose, Function
The tire pressure monitoring system warning light notifies the driver that
it was determined that a tire pressure has decreased below the specified value
based on the initialization.
The tire pressure monitoring system warning light notifies the driver that
...
PID/Data Monitor Inspection [Front Body Control Module (Fbcm)]
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the M-MDS.
a. Select “DataLogger”.
b. Select “Modules”.
c. Select “F_BCM”.
3. Select the applicable PID from the PID table.
4. Verify the PID ...
