Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Intermediate Shaft Removal/Installation

Mazda CX-5 Service & Repair Manual / Drivetrain / Driveline / Driveshafts / Intermediate Shaft Removal/Installation

WARNING:

1. Rotate the steering wheel until the joint bolt is in a position in which it can be removed.

CAUTION:

2. Lock the adjusting lever.

3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.



1

Joint cover

2

Intermediate shaft

(See Intermediate Shaft Removal Note.)

(See Intermediate Shaft Installation Note.)


Intermediate Shaft Removal Note

1. Place an alignment mark across the break between the steering column and the yoke for the intermediate shaft as shown in the figure.


2. Place alignment marks on the steering gear (pinion) and the intermediate shaft as shown in the figure.


3. Remove joint bolt A, then joint bolt B.


4. Remove the intermediate shaft.

Intermediate Shaft Installation Note

1. Place alignment marks on the new intermediate shaft in the same positions as the removed intermediate shaft.


2. Align the alignment marks on the steering column and the steering gear (pinion), which were placed before removing the intermediate shaft, and install the intermediate shaft.


NOTE:

3. Verify that the joint bolt B flange is seated in the specified position.


4. Verify that joint bolt A is installed to the groove of the steering gear (pinion).


Front Drive Shaft Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before ...

Propeller Shaft Inspection
1. Measure the propeller shaft center runout using the dial gauge. If it exceeds the maximum specification, replace the propeller shaft as a single component. Propeller shaft m ...

Other materials:

Crankshaft Position (CKP) Sensor Inspection
Visual Inspection CAUTION: When foreign material such as an iron chip is on the CKP sensor, it can cause abnormal output from the sensor because of flux turbulence and adversely affect the engine control. Be sure there is no foreign material on the CKP sensor when replacing. ...

Sunvisors
When you need a sunvisor, lower it for use in front or swing it to the side. Side Extension Sunvisors The visor extender extends the sunvisor's range of sun shading. To use, pull it out. CAUTION When moving the sunvisor, retract the visor extender to its original position. Otherwise, ...

Rear Drive Shaft Inspection
1. Inspect each connecting part for looseness. Tighten or replace parts if necessary. 2. Inspect the dust boot on the drive shaft for cracks, damage, leaking grease, and looseness in the boot band. 3. Inspect the drive shaft for bends, cracks, and wear in the joints or ...

© 2016-2022 Copyright www.mcx5.org