Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Intermediate Shaft Removal/Installation

Mazda CX-5 Service & Repair Manual / Drivetrain / Transmission/Transaxle / Automatic / Intermediate Shaft Removal/Installation

WARNING:

1. Rotate the steering wheel until the joint bolt is in a position in which it can be removed.

CAUTION:

2. Lock the adjusting lever.

3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.



1

Joint cover

2

Intermediate shaft

(See Intermediate Shaft Removal Note.)

(See Intermediate Shaft Installation Note.)


Intermediate Shaft Removal Note

1. Place an alignment mark across the break between the steering column and the yoke for the intermediate shaft as shown in the figure.


2. Place alignment marks on the steering gear (pinion) and the intermediate shaft as shown in the figure.


3. Remove joint bolt A, then joint bolt B.


4. Remove the intermediate shaft.

Intermediate Shaft Installation Note

1. Place alignment marks on the new intermediate shaft in the same positions as the removed intermediate shaft.


2. Align the alignment marks on the steering column and the steering gear (pinion), which were placed before removing the intermediate shaft, and install the intermediate shaft.


NOTE:

3. Verify that the joint bolt B flange is seated in the specified position.


4. Verify that joint bolt A is installed to the groove of the steering gear (pinion).


Initial Learning [Fw6 A EL, Fw6 Ax EL]
Introduction If the control valve body and oil pressure switch are replaced, always perform the initial learning. If the initial learning is not completed, engine rev-up may occur or shif ...

Judder Upon Torque Converter Clutch (TCC) Operation [Fw6 A EL, Fw6 Ax EL]
TROUBLESHOOTING ITEM Judder upon torque converter clutch (TCC) operation DESCRIPTION Vehicle jolts when TCC is engaged. ...

Other materials:

Brake Fluid Pressure Sensor
Purpose/Function The brake fluid pressure sensor detects the fluid pressure from the master cylinder and transmits it to the DSC HU/CM. Construction The brake fluid pressure sensor is built into the DSC HU/CM. Therefore if there is any malfunction of the brake fluid pressur ...

Engine Coolant Temperature (ECT) Sensor
Purpose/Function Detects the ECT as basic information for mainly determining the fuel injection amount. Detects the ECT and inputs it to the PCM as an ECT signal. The ECT sensor No.2 is only used for OBD. Construction ECT sensor No.1 Installed to the water out ...

A/C Compressor Control [Full Auto Air Conditioner]
Purpose The A/C compressor control switches the A/C compressor on/off according to the vehicle environment. Function The A/C compressor control turns the A/C compressor on/off based on the climate control unit operation and signals from each sensor. The A/C compress ...

© 2016-2022 Copyright www.mcx5.org