1. Disconnect the evaporative hose No.3 (purge solenoid valve side) and install the vacuum gauge..
2. Verify that the intake air hoses are installed securely.
3. Warm up the engine.
4. Measure the intake manifold vacuum while idling (no load) using the vacuum gauge.
If not within the specification, perform the following inspections.
Compression pressure.
Check valve.
Air suction
Installation areas of each vacuum hose
Installation area of throttle body
Installation area of fuel injector
Installation area of PCV valve
Installation area of intake manifold
Approx. –60.0 kPa {–450.0 mmHg, –17.7 inHg}
Towing
Towing Description
Proper lifting and towing are necessary to prevent damage to the vehicle.
Government and local laws must be followed.
A towed vehicle usually should have its drive wheels (front wheels) off the
ground. If excessive damage or other conditions prevent this, use ...
Front Map Light
Purpose
The front map lights shine light at the front of the vehicle interior.
Function
The front map lights illuminate when the map light switch is turned on.
Illuminates according to the lock condition of the driver's door and open/close
conditions of the doors u ...
Front Door Latch Switch Inspection
1. Perform the front door glass preparation..
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Front door glass.
d. Front door module panel.
e. Front door key cylinder.
f. Front door latch and lock actuator.
4. Verif ...